live power to usb cable
On my USB cables that have connectors on both ends, one end is live when the other end is plugged into the computer. I can get a pretty decent shock from the other end of the cable. This seems kind of dangerous. Am I barking up the wrong tree here or is this an issue that should be fixed?
--Geoff Mishkin <[email protected]>
Quoted 5 lines · Geoff Mishkin
On my USB cables that have connectors on both ends, one end is live when the other end is plugged into the computer. I can get a pretty decent shock from the other end of the cable. This seems kind of dangerous. Am I barking up the wrong tree here or is this an issue that should be fixed?
There isn't enough voltage present on a normal USB cable to be felt or even remotely harmful. If you're getting shocked by your cable it's probably due to an electrical mains wiring fault. Make certain your computer power supply is properly grounded (i.e. your power cable, outlet strip, and wall outlet are all grounded). If you have a voltmeter, test for AC voltage between the shell of the USB cable (or an unpainted spot on the computer's case) and another ground. Chances are good your electrical wiring is messed up. You can pick up a universal little tester with 3 lights on it at Wal-Mart for $10 or so. It'll tell you if any of the circuit legs are miswired.
I lived in an apartment once where there was nearly 65 volts AC between the grounds of two different circuits. I first noticed it when I grabbed the end of a serial cable in one hand and went to plug it into the back of a computer on another circuit. Woke me right up.
--Adam
Quoted 3 lines · Geoff Mishkin
On my USB cables that have connectors on both ends, one end is live when the other end is plugged into the computer.
Try re-compiling the kernel without CONFIG_USB_CATTLE_PROD.
André