RAID1 + rsync

I'm looking at a method of creating maximum redundancy using software RAID with four equal disks. I know that the most common advice is to do RAID 5 if there are four disks and redundancy is required.

Still, redundancy really is more important to me than performance (within reason of course). I know that a four disk RAID1 array (including swap) built out of primary and secondary masters/slaves would not perform well.

So I'm wondering if anyone has any comments on the following scenario, or has tried it. Let's assume partitioning is /boot, swap and /(root):

/dev/hda

1. Put /boot on a four disk array across all disks (dev/md0).
2. Put swap on a two disk array (primary and secondary masters) (/dev/md1).
3. Put /(root) on a two disk array (primary and secondary masters) (/dev/md2).

So I end up with something like this (all RAID autodetect type):

/dev/md0 /dev/hda1, /dev/hdb1, /dev/hdc1, /dev/hdd1 /boot /dev/md2 /dev/hda2, /dev/hdc2 swap
/dev/md2 /dev/hda3, /dev/hdc3 /

4. Set the remaining /dev/hdb2 and /dev/hdd2 partitions as swap type partitions.
5. Set and format the remaining /dev/hdb3 and /dev/hdd3 partitions as normal ext2 type partitions.
6. Run rsync daily to mirror /(root) on /dev/md2 to both /dev/hdb3 and /dev/hdd3.

I'm hoping that this would create something like a four disk RAID1 array with the performance of a two disk RAID1 array, and that in theory up to 3 of 4 disks could fail but a usable system would still be bootable (even if it may be the case that the system may only be as up to date as the last rsync process). I realise that depending on which disk(s) failed, I may have to use a boot/rescue disk to fiddle lilo (change / partition) and maybe fstab (change swap partition).

Does this idea have wheels, or am I overlooking some fatal flaw?

Thanks
Mick

--
Ninti Systems: Smart IT Solutions
Michael Hall
Mobile: 0429 095 392
Ph/Fax: 08 8953 1442       
Email:  office at ninti dot com dot au
Web:    http://ninti.com.au
--