Module unloading policy (should be killed from .config ?)
Hi all...
Since 2.6.8.1-mm3, my system hangs when I modprobe -r ipt_MASQUERADE (yup, you guessed, its an SMP box). Just locks hard.
A kernel build without module unloading seems to work. I heard about module unloading not being safe, but this is the first time it hits me seriously. If it is so dangerous and deprecated, why is still in Kconfig ? Could you kill it and remove the code completely ? Because I suppose that the idea is not to fix drivers...
But I guess this is going to break a lot of distros. At least Mandrake initscripts is plenty of <modprobe, test, rmmod | modprobe -r> snippets. Do not know if this is going to break cases like
modprobe -r xxxx || do_more
Could modprobe at least return 0 to the shell when removing ?
What is going on ?
TIA
--
J.A. Magallon <jamagallon()able!es> \ Software is like sex:
werewolf!able!es \ It's better when it's free
Mandrakelinux release 10.1 (Beta 1) for i586
Linux 2.6.8.1-mm4 (gcc 3.4.1 (Mandrakelinux (Alpha 3.4.1-3mdk)) #8
Quoted 8 lines · J.A. Magallon
Hi all...
Since 2.6.8.1-mm3, my system hangs when I modprobe -r
ipt_MASQUERADE(yup, you guessed, its an SMP box). Just locks hard.A kernel build without module unloading seems to work. I heard about module unloading not being safe, but this is the first time it hits me seriously.
I wrote a script a while ago that modprobe'd & rmmod'd every module it could find. Results weren't pretty.
Lessons learned:
- lots of driver writers don't take into consideration the fact the hardware might not be present when the driver does probing.
- Those that do, fail to clean up properly in this case.
- A lot of drivers leave junk in sysfs/procfs after rmmod which causes great fun for the next driver that gets loaded that uses the same subsystems.
It's been a few months since I last ran that script, but I'll bet the results today aren't much better than they were back then despite a bunch of problems I reported getting fixed.
Dave