Skip to contentSkip to conversation

PATCH: Misrouted IRQ recovery, take 2

DISCUSSION David R 2 participants 2 messages Sep 6, 2004

lore
Share & tools
lore

David R

author
#0 lore raw

Quoting Alan Cox <[email protected]>:

I'm probably being stupid... but in misrouted_irq(), shouldn't the 'work' flag be reset for each irq, rather than initialised outside the main loop?

David

#1 lore raw
Quoted 5 lines · David R

Quoting Alan Cox <[email protected]>:

I'm probably being stupid... but in misrouted_irq(), shouldn't the 'work' flag be reset for each irq, rather than initialised outside the main loop?

You are correct.

Ok try this

arch/i386/kernel/irq.c +151 -4
@@ -273,12 +273,103 @@ static int noirqdebug;
 static int __init noirqdebug_setup(char *str)
 {
 	noirqdebug = 1;
-	printk("IRQ lockup detection disabled\n");
+	printk(KERN_INFO "IRQ lockup detection disabled\n");
 	return 1;
 }
 
 __setup("noirqdebug", noirqdebug_setup);
 
+static int irqfixup;
+
+static int __init irqfixup_setup(char *str)
+{
+	irqfixup = 1;
+	printk(KERN_WARNING "Misrouted IRQ fixup support enabled.\n");
+	printk(KERN_WARNING "This may impact system performance.\n");
+	return 1;
+}
+
+__setup("irqfixup", irqfixup_setup);
+
+static int __init irqpoll_setup(char *str)
+{
+	irqfixup = 2;
+	printk(KERN_WARNING "Misrouted IRQ fixup and polling support enabled.\n");
+	printk(KERN_WARNING "This may significantly impact system performance.\n");
+	return 1;
+}
+
+__setup("irqpoll", irqpoll_setup);
+
+/*
+ *	Recovery handler for misrouted interrupts
+ */
+
+static asmlinkage int misrouted_irq(int irq, struct pt_regs *regs)
+{
+	int i;
+	irq_desc_t *desc;
+	int ok = 0;
+	for(i = 1; i < NR_IRQS; i++)
+	{
+		int work = 0;	/* Did we do work for a real IRQ */
+		struct irqaction *action;
+		if(i == irq)	/* Already tried */
+			continue;
+		desc = &irq_desc[i];
+		spin_lock(&desc->lock);
+		action = desc->action;
+		/* Already running on another processor */
+		if(desc->status & IRQ_INPROGRESS)
+		{
+			/* Already running: If it is shared get the other
+			   CPU to go looking for our mystery interrupt too */
+			if(desc->action && (desc->action->flags & SA_SHIRQ))
+				desc->status |= IRQ_PENDING;
+			spin_unlock(&desc->lock);
+			continue;
+		}
+		/* Honour the normal IRQ locking */
+		desc->status |= IRQ_INPROGRESS;
+		spin_unlock(&desc->lock);
+		while(action)
+		{
+			/* Only shared IRQ handlers are safe to call */
+			if(action->flags & SA_SHIRQ)
+			{
+				if(action->handler(i, action->dev_id, regs) == IRQ_HANDLED)
+					ok = 1;
+			}
+			action = action->next;
+		}
+		local_irq_disable();
+		/* Now clean up the flags */
+		spin_lock(&desc->lock);
+		action = desc->action;
+
+		/* While we were looking for a fixup someone queued a real
+		   IRQ clashing with our walk */
+
+		while((desc->status & IRQ_PENDING) && action)
+		{
+			/* Perform real IRQ processing for the IRQ we deferred */
+			work = 1;
+			spin_unlock(&desc->lock);
+			handle_IRQ_event(i, regs, action);
+			spin_lock(&desc->lock);
+			desc->status &= ~IRQ_PENDING;
+		}
+		desc->status &= ~IRQ_INPROGRESS;
+		/* If we did actual work for the real IRQ line we must
+		   let the IRQ controller clean up too */
+		if(work)
+			desc->handler->end(i);
+		spin_unlock(&desc->lock);
+	}
+	/* So the caller can adjust the irq error counts */
+	return ok;
+}
+
 /*
  * If 99,900 of the previous 100,000 interrupts have not been handled then
  * assume that the IRQ is stuck in some manner.  Drop a diagnostic and try to
@@ -289,13 +380,69 @@ __setup("noirqdebug", noirqdebug_setup);
  *
  * Called under desc->lock
  */
-static void note_interrupt(int irq, irq_desc_t *desc, irqreturn_t action_ret)
+static void note_interrupt(int irq, irq_desc_t *desc, irqreturn_t action_ret, struct pt_regs *regs)
 {
 	if (action_ret != IRQ_HANDLED) {
 		desc->irqs_unhandled++;
 		if (action_ret != IRQ_NONE)
 			report_bad_irq(irq, desc, action_ret);
 	}
+	if(unlikely(irqfixup))	/* Don't punish working computers */
+	{
+		if((irqfixup == 2 && irq == 0) || action_ret == IRQ_NONE)
+		{
+#ifdef CONFIG_4KSTACKS
+			u32 *isp;
+			union irq_ctx * curctx;
+			union irq_ctx * irqctx;
+			int ok;
+
+			curctx = (union irq_ctx *) current_thread_info();
+			irqctx = hardirq_ctx[smp_processor_id()];
+
+			spin_unlock(&desc->lock);
+
+			/*
+			 * this is where we switch to the IRQ stack. However, if we are already using
+			 * the IRQ stack (because we interrupted a hardirq handler) we can't do that
+			 * and just have to keep using the current stack (which is the irq stack already
+			 * after all)
+			 */
+
+			if (curctx == irqctx)
+				ok = misrouted_irq(irq, regs);
+			else {
+				/* build the stack frame on the IRQ stack */
+				isp = (u32*) ((char*)irqctx + sizeof(*irqctx));
+				irqctx->tinfo.task = curctx->tinfo.task;
+				irqctx->tinfo.previous_esp = current_stack_pointer();
+
+				*--isp = (u32) regs;
+				*--isp = (u32) irq;
+
+				asm volatile(
+				"       xchgl   %%ebx,%%esp     \n"
+				"       call    misrouted_irq   \n"
+				"       xchgl   %%ebx,%%esp     \n"
+				: "=a"(ok)
+				: "b"(isp)
+				: "memory", "cc", "edx", "ecx"
+				);
+			}
+			spin_lock(&desc->lock);
+			if (curctx != irqctx)
+				irqctx->tinfo.task = NULL;
+#else
+			spin_unlock(&desc->lock);
+
+			ok = misrouted_irq(irq, desc, regs);
+
+			spin_lock(&desc->lock);
+#endif
+			if(action_ret == IRQ_NONE)
+				desc->irqs_unhandled -= ok;
+		}
+	}
 
 	desc->irq_count++;
 	if (desc->irq_count < 100000)
@@ -532,7 +679,7 @@ asmlinkage unsigned int do_IRQ(struct pt
 		}
 		spin_lock(&desc->lock);
 		if (!noirqdebug)
-			note_interrupt(irq, desc, action_ret);
+			note_interrupt(irq, desc, action_ret, &regs);
 		if (curctx != irqctx)
 			irqctx->tinfo.task = NULL;
 		if (likely(!(desc->status & IRQ_PENDING)))
@@ -551,7 +698,7 @@ asmlinkage unsigned int do_IRQ(struct pt
 
 		spin_lock(&desc->lock);
 		if (!noirqdebug)
-			note_interrupt(irq, desc, action_ret);
+			note_interrupt(irq, desc, action_ret, &regs);
 		if (likely(!(desc->status & IRQ_PENDING)))
 			break;
 		desc->status &= ~IRQ_PENDING;