Skip to contentSkip to conversation

[2.6.8 ->] Problems, hci_usb dosn't work.

DISCUSSION Ian Kumlien 1 participant 1 message Sep 22, 2004

lore
Share & tools
lore
#0 lore raw

[A, Snipped from a mail to the BlueZ ppl. B, CC:ed since the last post
on USB was in the year 2000]

What the bluez developer gathered:
This looks really like an ohci_hcd problem with interrupt URBs.

Controllers and drivers:
ehci_hcd 0000:00:02.2: nVidia Corporation nForce2 USB Controller ehci_hcd 0000:00:02.2: irq 193, pci mem f8814000
ehci_hcd 0000:00:02.2: new USB bus registered, assigned bus number 1 ehci_hcd 0000:00:02.2: USB 2.0 enabled, EHCI 1.00, driver 2004-May-10
ohci_hcd: 2004 Feb 02 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) ohci_hcd 0000:00:02.0: nVidia Corporation nForce2 USB Controller ohci_hcd 0000:00:02.0: irq 177, pci mem f8816000
ohci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 2 ohci_hcd 0000:00:02.1: nVidia Corporation nForce2 USB Controller (#2) ohci_hcd 0000:00:02.1: irq 185, pci mem f8818000
ohci_hcd 0000:00:02.1: new USB bus registered, assigned bus number 3

And the final error when inserting a USB BT dongle:
usb 1-3.4: new full speed USB device using address 12 ehci_hcd 0000:00:02.2: qh f7e54680 (#0) state 1
hci_usb_intr_rx_submit: hci0 intr rx submit failed urb f7b81274 err -28

from proc/interrupts:

177:          0   IO-APIC-level  ohci_hcd
185:          0   IO-APIC-level  ohci_hcd
193:      24812   IO-APIC-level  ehci_hcd
CC Since i'm not subbed to either ml.

Some snipped parts from the original mail.
---
Since some kernel version i can't exactly remember which, i have been unable to use usb, i have tested with with 2.6.8 -> 2.6.9-rc2-bk7 and i also applied your patches for 2.6.8.

I have 2 usb dongles, one old that did work once, and one new that seems to be working like the older but it doesn't work with linux.

Output from hciconfig:
hci0: Type: USB
BD Address: 00:00:00:00:00:00 ACL MTU: 0:0 SCO MTU: 0:0 DOWN
RX bytes:0 acl:0 sco:0 events:0 errors:0
TX bytes:0 acl:0 sco:0 commands:0 errors:0

Basically, it just stopped working and i dunno why, any clues? at all?

Signature · 1 line
Ian Kumlien <pomac () vapor ! com> -- http://pomac.netswarm.net