How to control make '-j' parallel job limit?
Quoted 7 lines · Thomas Petazzoni via buildroot
Quoted 4 lines · Grant Edwards
How, from the command-line, do we control the '-j' value used by buildroot when doing makes?
We have
BR2_JLIMITset to 0 (auto), and most of the time it uses anI assume you're talking about
BR2_JLEVEL.
[...]
Quoted 3 lines
I must be confused by your question, because the answer is in the question itself: use
BR2_JLEVEL. Set it to 8, and it will pass -j8 when building packages.
Doh! My apologies. As you noticed, about one time out of three I seem to type LIMIT instead of LEVEL, and they're visually similar enough that I don't notice even after looking at the file repeatedly.
I apparently tested
make BR2_JLIMIT=3
instead of
make BR2_JLEVEL=3
Sorry for the noise.
--
Grant
_______________________________________________
buildroot mailing list
[email protected]
https://lists.buildroot.org/mailman/listinfo/buildroot
Quoted 6 lines · Grant Edwards
Doh! My apologies. As you noticed, about one time out of three I seem to type LIMIT instead of LEVEL, and they're visually similar enough that I don't notice even after looking at the file repeatedly.
I apparently tested
Quoted 7 lines
make BR2_JLIMIT=3
instead of
make BR2_JLEVEL=3
Sorry for the noise.
No worries, glad that it works for you now!
Thomas
Signature · 7 lines
Thomas Petazzoni, co-owner and CEO, Bootlin Embedded Linux and Kernel engineering and training https://bootlin.com _______________________________________________ buildroot mailing list [email protected] https://lists.buildroot.org/mailman/listinfo/buildroot