Skip to contentSkip to conversation

TLB IPI FLushTLB vs Invl Page

DISCUSSION [email protected] 1 participant 1 message Sep 2, 2008

lore
Share & tools
lore
#0 lore raw

Analysis on this one has been done by others on other OS's. Results are:

NMI IPI which results in TLB flush

mov eax, cr3
mov cr3,eax

vs.

invlpg [page]

TLB flushing always blows out the TLB and it usually takes 150 clocks (cumulative over time) for the processor to recover. invlpage is more lightweight but takes around 100 clocks for the system to recover.

Easiest way to measure the two is to write a short program loop that does something like (holding the processor into this loop):

while (1)
{
FlushTLB();
counter++;
}

vs.

while (1)
{
Invlpg(page);
counter++;
}

and compare which one counts higher on all processors -- this one is less overhead on the bus overall.

I did the same tests many years ago and compared these two instructions.

results were invlpg saves you on performance but overall was no better than flushing the entire TLB since you end up ending more IPI's on average.

Jeff