client socket and source port selection
HI,
For the project i'm doing, i must know how the Linux kernel allocate sockets source port (from the dynamic range of the (2**16)-1 ports). I looked on the Web but it's really hard to find the algoritm of the source port allocation...
Someone maybe know how it's work or if there is a paper on the web that explain this source port selection ?
Thanks a lot for your help !
Joël.W
Quoted 9 lines
HI,
For the project i'm doing, i must know how the Linux kernel allocate sockets source port (from the dynamic range of the (2**16)-1 ports). I looked on the Web but it's really hard to find the algoritm of the source port allocation...
Someone maybe know how it's work or if there is a paper on the web that explain this source port selection ?
I think it starts at 1024 when it boots, and increments whenever a socket is created.
Jan Engelhardt
Signature · 2 lines
Gesellschaft für Wissenschaftliche Datenverarbeitung Am Fassberg, 37077 Göttingen, www.gwdg.de
Hello,
Quoted 4 lines
For the project i'm doing, i must know how the Linux kernel allocate sockets source port (from the dynamic range of the (2**16)-1 ports). I looked on the Web but it's really hard to find the algoritm of the source port allocation...
Check the source ;). There is a proc-fs entry which relates to the source port range setting. Over this entry point you get in case of TCP sockets to ../net/ipv4/tcp_ipv4.c:tcp_v4_get_port(...). For UDP sockets you need to peek into ../net/ipv4/udp.c:udp_v4_get_port().
Quoted 2 lines
Someone maybe know how it's work or if there is a paper on the web that explain this source port selection ?
Not likely, but reading the source should help. You can set the local port range via /proc/sys/net/ipv4/ip_local_port_range. It's documented.
HTH and best regards,
Roberto Nibali, ratz
Signature · 1 line
echo '[q]sa[ln0=aln256%Pln256/snlbx]sb3135071790101768542287578439snlbxq' | dc