Skip to contentSkip to conversation

INVALID CHECKSUM error (In Linux Video Capture Interface?)

DISCUSSION Michael Thomas Heath 2 participants 2 messages Dec 1, 2004

lore
Share & tools
lore
#0 lore raw

I recently underwent the effort to setup an older parallel Colour QuickCam on Linux using the Video4Linux interface. However, when I went to boot, I got an "INVALID CHECKSUM 0005" error:

3c59x: Donald Becker and others. www.scyld.com/network/vortex.html 0000:00:09.0: 3Com PCI 3c900 Cyclone 10Mbps TPO at 0xd400. Vers LK1.1.19
***INVALID CHECKSUM 0005*** <6>Linux video capture interface: v1.00
Colour QuickCam for Video4Linux v0.05
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2

I've never encountered an error like this before; I asked around and people suggested testing my RAM (Which I did, everything was fine), and recompiling my kernel. I recompiled my kernel image, and used dd to copy to avoid errors in the copying of the kernel.

I'd apreaciate you CC any replies to my home e-
mail, "[email protected]"

#1 lore raw
Quoted 11 lines · Michael Thomas Heath

I recently underwent the effort to setup an older parallel Colour QuickCam on Linux using the Video4Linux interface. However, when I went to boot, I got an "INVALID CHECKSUM 0005" error:

3c59x: Donald Becker and others. www.scyld.com/network/vortex.html 0000:00:09.0: 3Com PCI 3c900 Cyclone 10Mbps TPO at 0xd400. Vers LK1.1.19
***INVALID CHECKSUM 0005*** <6>Linux video capture interface: v1.00
Colour QuickCam for Video4Linux v0.05
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2

Quoted 4 lines

I've never encountered an error like this before; I asked around and people suggested testing my RAM (Which I did, everything was fine), and recompiling my kernel. I recompiled my kernel image, and used dd to copy to avoid errors in the copying of the kernel.

It is the network card... (you can find the message in drivers/net/3c59x.c) The 0005 is the difference between the incorrect checksum and the eprom version

I believe there is an utility (also written by D. Becker) that can fix this. It isn't a severe error - I've seen this after a W95 boot on other interfaces, and I'm not sure why it occurs... (In the windows case, the problem was cleared for every other reboot - wierd.)

In my case, it happens on a 3c509 card, and the utility is a 3c5x9setup.c It allows inspection of the eprom on the network card, and had the ability to recompute the checksum and update it. I suspect your card has a similar capability to be programmed (like a netboot .

In your case you might look for a 3c59??setup.c utility. For all I know it may be the SAME utility.

I checked www.scyld.com for such an utility, but got some "page not found" reportedly because of incompleted updates.

I don't think it should cause a problem, the driver looks like it goes ahead and completes setup anyway. I think of it more as a hint of possible problem, not an actual problem. The checksum SHOULD be correct, but isn't.

Quoted 7 lines

I'd apreaciate you CC any replies to my home e-
mail, "[email protected]"
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/