Skip to contentSkip to conversation

Lousing interrupt with Geode

DISCUSSION Xose Manuel Fernandez Lorenzo 1 participant 1 message Jan 27, 2005

lore
Share & tools
lore
#0 lore raw

I have a IAC-H553 Board with a NS Geode Low-Power CPU:

Working around Cyrix MediaGX virtual DMA bugs.
Enable Memory-Write-back mode on Cyrix/NSC processor. Enable Memory access reorder on Cyrix/NSC processor.
Enable Incrementor on Cyrix/NSC processor.
CPU: After all inits, caps: 00808131 00818131 00000000 00000001
CPU: Cyrix Geode(TM) Integrated Processor by National Semi stepping 02 Checking 'hlt' instruction... OK.

with a chipset CS5530A Geode.

I have also a Digital Input Output card, and I have develop a board to generate an interrupt when and input change.

This has been working under MS-DOS properly, but in Linux i lose some interrupt (I do not get my isr routine called and in /proc/interrupts the counter do not increment).

If I use the same Digital Input Output card whit another CPU and linux everithing work property.

Have someone find the same problem with Geode?

I use the kernel 2.6.5 from debian with Preemtive.

I am nos suscribe to the kernel list, so please response also to my email.

Thanks in advance