Add new MPC8548CDS board with DDR II

diff -Nru --exclude=CVS u-boot/include/spd.h u-boot-pq3/include/spd.h
@@ -25,54 +25,84 @@
 #define _SPD_H_
 
 typedef struct spd_eeprom_s {
-   unsigned char info_size;   /* # of bytes written into serial memory           */
-   unsigned char chip_size;   /* Total # of bytes of SPD memory device           */
-   unsigned char mem_type;    /* Fundamental memory type (FPM, EDO, SDRAM...)    */
-   unsigned char nrow_addr;   /* # of Row Addresses on this assembly             */
-   unsigned char ncol_addr;   /* # of Column Addresses on this assembly          */
-   unsigned char nrows;       /* # of Module Rows on this assembly               */
-   unsigned char dataw_lsb;   /* Data Width of this assembly                     */
-   unsigned char dataw_msb;   /* ... Data Width continuation                     */
-   unsigned char voltage;     /* Voltage interface standard of this assembly     */
-   unsigned char clk_cycle;   /* SDRAM Cycle time at CL=X                        */
-   unsigned char clk_access;  /* SDRAM Access from Clock at CL=X                 */
-   unsigned char config;      /* DIMM Configuration type (non-parity, ECC)       */
-   unsigned char refresh;     /* Refresh Rate/Type                               */
-   unsigned char primw;       /* Primary SDRAM Width                             */
-   unsigned char ecw;         /* Error Checking SDRAM width                      */
-   unsigned char min_delay;   /* Min Clock Delay for Back to Back Random Address */
-   unsigned char burstl;      /* Burst Lengths Supported                         */
-   unsigned char nbanks;      /* # of Banks on Each SDRAM Device                 */
-   unsigned char cas_lat;     /* CAS# Latencies Supported                        */
-   unsigned char cs_lat;      /* CS# Latency                                     */
-   unsigned char write_lat;   /* Write Latency (also called Write Recovery time) */
-   unsigned char mod_attr;    /* SDRAM Module Attributes                         */
-   unsigned char dev_attr;    /* SDRAM Device Attributes                         */
-   unsigned char clk_cycle2;  /* Min SDRAM Cycle time at CL=X-1                  */
-   unsigned char clk_access2; /* SDRAM Access from Clock at CL=X-1               */
-   unsigned char clk_cycle3;  /* Min SDRAM Cycle time at CL=X-2                  */
-   unsigned char clk_access3; /* Max SDRAM Access from Clock at CL=X-2           */
-   unsigned char trp;         /* Min Row Precharge Time (tRP)                    */
-   unsigned char trrd;        /* Min Row Active to Row Active (tRRD)             */
-   unsigned char trcd;        /* Min RAS to CAS Delay (tRCD)                     */
-   unsigned char tras;        /* Minimum RAS Pulse Width (tRAS)                  */
-   unsigned char row_dens;    /* Density of each row on module                   */
-   unsigned char ca_setup;    /* Command and Address signal input setup time     */
-   unsigned char ca_hold;     /* Command and Address signal input hold time      */
-   unsigned char data_setup;  /* Data signal input setup time                    */
-   unsigned char data_hold;   /* Data signal input hold time                     */
-   unsigned char sset[26];    /* Superset Information (may be used in future)    */
-   unsigned char spd_rev;     /* SPD Data Revision Code                          */
-   unsigned char cksum;       /* Checksum for bytes 0-62                         */
-   unsigned char mid[8];      /* Manufacturer's JEDEC ID code per JEP-108E       */
-   unsigned char mloc;        /* Manufacturing Location                          */
-   unsigned char mpart[18];   /* Manufacturer's Part Number                      */
-   unsigned char rev[2];      /* Revision Code                                   */
-   unsigned char mdate[2];    /* Manufacturing Date                              */
-   unsigned char sernum[4];   /* Assembly Serial Number                          */
-   unsigned char mspec[27];   /* Manufacturer Specific Data                      */
-   unsigned char freq;        /* Intel specification frequency                   */
-   unsigned char intel_cas;   /* Intel Specification CAS# Latency support        */
+	unsigned char info_size;   /*  0 # bytes written into serial memory */
+	unsigned char chip_size;   /*  1 Total # bytes of SPD memory device */
+	unsigned char mem_type;    /*  2 Fundamental memory type */
+	unsigned char nrow_addr;   /*  3 # of Row Addresses on this assembly */
+	unsigned char ncol_addr;   /*  4 # of Column Addrs on this assembly */
+	unsigned char nrows;       /*  5 # of Module Rows on this assembly */
+	unsigned char dataw_lsb;   /*  6 Data Width of this assembly */
+	unsigned char dataw_msb;   /*  7 ... Data Width continuation */
+	unsigned char voltage;     /*  8 Voltage intf std of this assembly */
+	unsigned char clk_cycle;   /*  9 SDRAM Cycle time at CL=X */
+	unsigned char clk_access;  /* 10 SDRAM Access from Clock at CL=X */
+	unsigned char config;      /* 11 DIMM Configuration type */
+	unsigned char refresh;     /* 12 Refresh Rate/Type */
+	unsigned char primw;       /* 13 Primary SDRAM Width */
+	unsigned char ecw;         /* 14 Error Checking SDRAM width */
+	unsigned char min_delay;   /* 15 for Back to Back Random Address */
+	unsigned char burstl;      /* 16 Burst Lengths Supported */
+	unsigned char nbanks;      /* 17 # of Banks on Each SDRAM Device */
+	unsigned char cas_lat;     /* 18 CAS# Latencies Supported */
+	unsigned char cs_lat;      /* 19 CS# Latency */
+	unsigned char write_lat;   /* 20 Write Latency (aka Write Recovery) */
+	unsigned char mod_attr;    /* 21 SDRAM Module Attributes */
+	unsigned char dev_attr;    /* 22 SDRAM Device Attributes */
+	unsigned char clk_cycle2;  /* 23 Min SDRAM Cycle time at CL=X-1 */
+	unsigned char clk_access2; /* 24 SDRAM Access from Clock at CL=X-1 */
+	unsigned char clk_cycle3;  /* 25 Min SDRAM Cycle time at CL=X-2 */
+	unsigned char clk_access3; /* 26 Max Access from Clock at CL=X-2 */
+	unsigned char trp;         /* 27 Min Row Precharge Time (tRP)*/
+	unsigned char trrd;        /* 28 Min Row Active to Row Active (tRRD) */
+	unsigned char trcd;        /* 29 Min RAS to CAS Delay (tRCD) */
+	unsigned char tras;        /* 30 Minimum RAS Pulse Width (tRAS) */
+	unsigned char row_dens;    /* 31 Density of each row on module */
+	unsigned char ca_setup;    /* 32 Cmd + Addr signal input setup time */
+	unsigned char ca_hold;     /* 33 Cmd and Addr signal input hold time */
+	unsigned char data_setup;  /* 34 Data signal input setup time */
+	unsigned char data_hold;   /* 35 Data signal input hold time */
+	unsigned char twr;         /* 36 Write Recovery time tWR */
+	unsigned char twtr;        /* 37 Int write to read delay tWTR */
+	unsigned char trtp;        /* 38 Int read to precharge delay tRTP */
+	unsigned char mem_probe;   /* 39 Mem analysis probe characteristics */
+	unsigned char trctrfc_ext; /* 40 Extensions to trc and trfc */
+	unsigned char trc;         /* 41 Min Active to Auto refresh time tRC */
+	unsigned char trfc;        /* 42 Min Auto to Active period tRFC */
+	unsigned char tckmax;      /* 43 Max device cycle time tCKmax */
+	unsigned char tdqsq;       /* 44 Max DQS to DQ skew */
+	unsigned char tqhs;        /* 45 Max Read DataHold skew tQHS */
+	unsigned char pll_relock;  /* 46 PLL Relock time */
+	unsigned char res[15];     /* 47-xx IDD in SPD and Reserved space */
+	unsigned char spd_rev;     /* 62 SPD Data Revision Code */
+	unsigned char cksum;       /* 63 Checksum for bytes 0-62 */
+	unsigned char mid[8];      /* 64 Mfr's JEDEC ID code per JEP-108E */
+	unsigned char mloc;        /* 72 Manufacturing Location */
+	unsigned char mpart[18];   /* 73 Manufacturer's Part Number */
+	unsigned char rev[2];      /* 91 Revision Code */
+	unsigned char mdate[2];    /* 93 Manufacturing Date */
+	unsigned char sernum[4];   /* 95 Assembly Serial Number */
+	unsigned char mspec[27];   /* 99 Manufacturer Specific Data */
+
+	/*
+	 * Open for Customer Use starting with byte 128.
+	 */
+	unsigned char freq;        /* 128 Intel spec: frequency */
+	unsigned char intel_cas;   /* 129 Intel spec: CAS# Latency support */
 } spd_eeprom_t;
 
+
+/*
+ * Byte 2 Fundamental Memory Types.
+ */
+#define SPD_MEMTYPE_FPM		(0x01)
+#define SPD_MEMTYPE_EDO		(0x02)
+#define SPD_MEMTYPE_PIPE_NIBBLE	(0x03)
+#define SPD_MEMTYPE_SDRAM	(0x04)
+#define SPD_MEMTYPE_ROM		(0x05)
+#define SPD_MEMTYPE_SGRAM	(0x06)
+#define SPD_MEMTYPE_DDR		(0x07)
+#define SPD_MEMTYPE_DDR2	(0x08)
+
+
 #endif /* _SPD_H_ */
+