where is the interrupt vectors?
hello,
I am new to u-boot.
I want to support some perpherals which need use the I/O pins of INT. And it need to be allocated the vectors, depending on the INT ports. How does u-boot support this, and where I can find it?
Thank you,
Terry
Quoted 3 lines · In message <1132801697.2550.11.camel@PC6> you wrote:
I want to support some perpherals which need use the I/O pins of INT. And it need to be allocated the vectors, depending on the INT ports.
And which processor architecture is this?
Wolfgang Denk
Signature · 5 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de One essential to success is that you desire be an all-obsessing one, your thoughts and aims be co-ordinated, and your energy be concentra- ted and applied without letup.
Quoted 10 lines · Wolfgang Denk
Quoted 3 lines · In message <1132801697.2550.11.camel@PC6> you wrote:
I want to support some perpherals which need use the I/O pins of INT. And it need to be allocated the vectors, depending on the INT ports.
And which processor architecture is this?
Wolfgang Denk
I used arm926ejs.
regards,
Terry