Skip to contentSkip to conversation

forcedeth

DISCUSSION Jacques de Krahe 2 participants 2 messages Dec 2, 2005

lore
Share & tools
lore
#0 lore raw

Running FC4 on a PC equipped with NForce2 chipset and AMD k7 (Athlon XP 2200)
The eth interface can't be normally configured at boot and fails. The problem comes from forcedeth. The system asks me to have a look into dmesg, where I find a line that reads a follows: forcedeth : Unknown parameter "irq"
The next line in /var/log/dmesg shows the version number.
Is it possible to correct the code and what are the necessary steps to get a functional module?
If you answer my question, please be as complete as possible, I am a new user of FC4.
Thank in advance
Regards
Jacques de Krahe

#1 lore raw
Quoted 6 lines · Jacques de Krahe

Running FC4 on a PC equipped with NForce2 chipset and AMD k7 (Athlon XP 2200)
The eth interface can't be normally configured at boot and fails. The problem comes from forcedeth. The system asks me to have a look into dmesg, where I find a line that reads a follows: forcedeth : Unknown parameter "irq"

are you trying to load forcedeth with a parameter called "irq" ? if so, try without

Quoted 15 lines

The next line in /var/log/dmesg shows the version number.
Is it possible to correct the code and what are the necessary steps to get a functional module?
If you answer my question, please be as complete as possible, I am a new user of FC4.
Thank in advance
Regards
Jacques de Krahe

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/