Skip to contentSkip to conversation

cpufreq broken in 2.6.15-rc5

DISCUSSION Mark Rosenstand 1 participant 2 messages Dec 16, 2005 – Dec 17, 2005

lore
Share & tools
lore
#0 lore raw

Hi,

I'm using the ondemand governor with powernow-k8 on an Athlon 64 3200+ desktop. However, it's acting a bit strange:

# cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_max_freq
2000000
# cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_min_freq
2000000

This results in the processor always running at 100%.

The relevant part from dmesg:

powernow-k8: Found 1 AMD Athlon 64 / Opteron processors (version 1.50.4)
powernow-k8:    0 : fid 0x0 (800 MHz), vid 0xa (1300 mV)
powernow-k8:    1 : fid 0xa (1800 MHz), vid 0x6 (1400 mV)
powernow-k8:    2 : fid 0xc (2000 MHz), vid 0x2 (1500 mV)

cpu_init done, current fid 0xc, vid 0x2

My .config:

CONFIG_CPU_FREQ=y
CONFIG_CPU_FREQ_TABLE=y
# CONFIG_CPU_FREQ_DEBUG is not set CONFIG_CPU_FREQ_STAT=y CONFIG_CPU_FREQ_STAT_DETAILS=y
# CONFIG_CPU_FREQ_DEFAULT_GOV_PERFORMANCE is not set CONFIG_CPU_FREQ_DEFAULT_GOV_USERSPACE=y
# CONFIG_CPU_FREQ_GOV_PERFORMANCE is not set # CONFIG_CPU_FREQ_GOV_POWERSAVE is not set CONFIG_CPU_FREQ_GOV_USERSPACE=y CONFIG_CPU_FREQ_GOV_ONDEMAND=y
# CONFIG_CPU_FREQ_GOV_CONSERVATIVE is not set

I haven't tried any earlier rc's, but it works with 2.6.14. I'd be happy to answer any questions.

Thanks,
Mark

#1 lore raw

Re: cpufreq broken in 2.6.15-rc5 (Invalid)

Quoted 4 lines · Mark Rosenstand

Hi,

I'm using the ondemand governor with powernow-k8 on an Athlon 64 3200+ desktop. However, it's acting a bit strange:

Local screw-up. I'm sorry about the noise.