- Enable SPDIF output for DVB-S rev 2.3. Firmware 2623 or higher required.

PATCH In review Mauro Carvalho Chehab 1 participant 1 message Dec 18, 2005 Media (V4L/DVB)

lore

Share & tools

lore

Mauro Carvalho Chehab

author

2005-12-18 15:45 UTC #0 lore raw

PATCH 3/5 - Enable SPDIF output for DVB-S rev 2.3. Firmware 2623 or higher required.

- Enable SPDIF output for DVB-S rev 2.3. Firmware 2623 or higher required.

Signed-off-by Oliver Endriss <[email protected]>

Signed-off-by Mauro Carvalho Chehab <[email protected]>

---

 drivers/media/dvb/ttpci/av7110.c    |    3 +++
 drivers/media/dvb/ttpci/av7110_hw.h |    3 ++-
 2 files changed, 5 insertions(+), 1 deletions(-)

a2395ae2b8aefa35ef1a859f095f9c1a81a3ffe5

drivers/media/dvb/ttpci/av7110.c +3 -0

index 992be0b..7dae91e 100644
@@ -176,6 +176,9 @@ static void init_av7110_av(struct av7110
 		}
 	}
 
+	if (dev->pci->subsystem_vendor == 0x13c2 && dev->pci->subsystem_device == 0x000e)
+		av7110_fw_cmd(av7110, COMTYPE_AUDIODAC, SpdifSwitch, 1, 0); // SPDIF on
+
 	ret = av7110_set_volume(av7110, av7110->mixer.volume_left, av7110->mixer.volume_right);
 	if (ret < 0)
 		printk("dvb-ttpci:cannot set volume :%d\n",ret);

drivers/media/dvb/ttpci/av7110_hw.h +2 -1

index fedd20f..2a5e87b 100644
@@ -143,7 +143,8 @@ enum av7110_audio_command {
 	MainSwitch,
 	ADSwitch,
 	SendDiSEqC,
-	SetRegister
+	SetRegister,
+	SpdifSwitch
 };
 
 enum av7110_request_command {

Signature · 1 line

0.99.9.GIT