Switched default PCI speed for 8540 ADS back to 33MHz, Added comments and a printf to warn that PCI-X won't work at 33MHz
PATCH 11/11 Switched default PCI speed for 8540 ADS back to 33MHz, Added comments and a printf to warn that PCI-X won't work at 33MHz
* Switched default PCI speed for 8540 ADS back to 33MHz
* Added comments and a printf to warn that PCI-X won't work at 33MHz
Patch by Andy Fleming 17-Mar-2006
Signed-off-by Andy Fleming <[email protected]>
Signed-off-by Matthew McClintock <[email protected]>
--- cpu/mpc85xx/pci.c | 3 +++ doc/README.mpc85xxads | 3 +++ include/configs/MPC8540ADS.h | 6 +++++- 3 files changed, 11 insertions(+), 1 deletions(-)
cpu/mpc85xx/pci.c +3 -0
@@ -72,6 +72,9 @@ pci_mpc85xx_init(struct pci_controller *if (!(gur->pordevsr &PORDEVSR_PCI )) {/* PCI-X init */ +if (CONFIG_SYS_CLK_FREQ <66000000 ) +printf ("PCI-X will only work@66 MHz\n" ); + reg16 =PCI_X_CMD_MAX_SPLIT |PCI_X_CMD_MAX_READ |PCI_X_CMD_ERO |PCI_X_CMD_DPERR_E ;pci_hose_write_config_word (hose, dev,PCIX_COMMAND , reg16);
doc/README.mpc85xxads +3 -0
@@ -100,6 +100,9 @@ Updated 13-July-2004 Jon Loeliger SW7[1:4] = 0101 = 5 => 5 x 66 = 330 CCB Sysclk SW7[5:6] = 01 => 5:2 x 330 = 825 Core clock + In order to use PCI-X (only in the first PCI slot. The one with + the RIO connector), you need to set SW1[4] (config) to 1 (off). + Also, configure the board to run PCI at 66 MHz. 2. MEMORY MAP TO WORK WITH LINUX KERNEL
include/configs/MPC8540ADS.h +5 -1
@@ -68,10 +68,14 @@ #define CONFIG_MEM_INIT_VALUE 0xDeadBee* The board, however, can run at 66MHz. In any event, this value * must match the settings of some switches. Details can be found * in the README.mpc85xxads. +* +* XXX -- Can't we run at 66 MHz, anyway? PCI should drop to +* 33MHz to accommodate, based on a PCI pin. +* Note that PCI-X won't work at 33MHz. */ #ifndef CONFIG_SYS_CLK_FREQ -#define CONFIG_SYS_CLK_FREQ 66000000 +#define CONFIG_SYS_CLK_FREQ 33000000#endif
Signature · 1 line
2006_06_07.01.gittree_pull-dirty