Skip to contentSkip to conversation

add-features-to-trab-board- [...]

PATCH New DENX Support System 1 participant 1 message Aug 7, 2006

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 add-features-to-trab-board- [...]

Hello list,

inside the automatic U-Boot patch tracking system a follow up to [DNX#2006062142000057] was entered through the web interface:

<snip>

Quoted 22 lines

wd at denx.de wrote on Wednesday, July 19, 2006 2:57 PM:

Quoted 6 lines

In message <[email protected]> you

Quoted 3 lines · wrote:

Add features to TRAB board standalone test application.

Quoted 7 lines
Quoted 5 lines

- add "touch read" command
- the crc16 command now verifies the crc value written to the EEPROM
- use i2c_write_multiple() instead of i2c_write(), because = i2c_write_mulitple() waites for the EEPROM to finish its write
cycle

Sorry, this patch does not apply. Please clean up and resubmit.

OK. The attached patch should apply cleanly to top of git.

Regards,
Martin

CHANGELOG:

Quoted 7 lines

* Add features to TRAB board standalone test application.
- add "touch read" command
- the crc16 command now verifies the crc value written to the EEPROM
- use i2c_write_multiple() instead of i2c_write(), because
i2c_write_mulitple()
waites for the EEPROM to finish its write cycle
Patch by Martin Krause, 7 Aug 2006

</snip>

Your U-Boot support team