What the right procedure should be when write a new driver for U-boot?
Hi maintainer
There is some confusion about what the right procedure should be, when someone want to add some drivers to U-boot.
When I read U-boot's code, I found the devices initialize function devices_init() (called in /u-boot-x.x.x/lib_xxx/board.c), It creates a device list, then dev_xxx_init() register the devices such as LCD, USB, Serial, Keyboard in the list.
But, some SOC have their own drivers, for example s3c24x0 have their own driver of USB, Serial,(/cpu/arm920t/s3c24x0/usb_ohci.c) they don't care about the device list, they do it their way.
Is there any 'official' policy on it?
Quoted 5 lines · In message <1158829226.8962.35.camel@localhost> you wrote:
When I read U-boot's code, I found the devices initialize function
devices_init()(called in /u-boot-x.x.x/lib_xxx/board.c), It creates a device list, thendev_xxx_init()register the devices such as LCD, USB, Serial, Keyboard in the list.
The "devices" list is what can be used for assignement to the standard I/O "devices" (i. e. the stdin, stdout and stderr data streams).
Quoted 3 lines
But, some SOC have their own drivers, for example s3c24x0 have their own driver of USB, Serial,(/cpu/arm920t/s3c24x0/usb_ohci.c) they don't care about the device list, they do it their way.
Some devices like serial or LCD may be used for standard I/O streams, others (like USB or network may not.
Quoted 1 line
Is there any 'official' policy on it?
Yes - see above.
Best regards,
Wolfgang Denk
Signature · 3 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "In matrimony, to hesitate is sometimes to be saved." - Butler