libata: Winbond support
PATCH 1/1 libata: Winbond support
Winbond 83759A support in non-multichip mode (afaik nobody ever used multichip mode anyway). The 83759 is not supported by this driver as it is already handled elsewhere and doens't use the same interfaces.
Signed-off-by Alan Cox <[email protected]>
drivers/ata/Kconfig +7 -0
@@ -482,6 +491,13 @@ If unsure, say N. +config PATA_WINBOND_VLB + tristate "Winbond W83759A VLB PATA support (Experimental)" + depends on ISA && EXPERIMENTAL + help + Support for the Winbond W83759A controller on Vesa Local Bus + systems. + endif endmenu
drivers/ata/Makefile +1 -0
@@ -51,6 +52,7 @@ obj-$(CONFIG_PATA_SIL680) += pata_sil680.o obj-$(CONFIG_PATA_VIA) += pata_via.o obj-$(CONFIG_PATA_WINBOND) += pata_sl82c105.o +obj-$(CONFIG_PATA_WINBOND_VLB) += pata_winbond.o obj-$(CONFIG_PATA_SIS) += pata_sis.o obj-$(CONFIG_PATA_TRIFLEX) += pata_triflex.o # Should be last but one libata driver
drivers/ata/pata_winbond.c +306 -0
306 lines not on this page · raw message
Jeff Garzik
AppliedQuoted 5 lines · Alan Cox
Winbond 83759A support in non-multichip mode (afaik nobody ever used multichip mode anyway). The 83759 is not supported by this driver as it is already handled elsewhere and doens't use the same interfaces.
Signed-off-by Alan Cox <[email protected]>
applied to #upstream, but you need to quit adding trailing whitespace :)