Skip to contentSkip to conversation

ML403 Uboot Linux Boot Error

U-Boot-Users alayrac christophe 2 participants 2 messages Oct 6, 2006

lore
Share & tools
lore
#0 lore raw

I'm coming back to the comunitee with good news , especially for me !-)

I succeed to start linux (2-4.26) from u-boot 1.1.4 on ML403.

When U-boot start I press enter to stop autostart.

Then I type the following commands :

	=> setenv bootargs
	=> fatload ace 0 400000 linux/vmlinux.uboot
	=> bootm 400000

In fact the first command is the reason of hang up after
#Uncompressing Kernel Image .... Ok
My goal was to preserve command line set up in the Kernel configuration (using NFS)

If I type only the last two commands, the Kernel start properly on the root file system of the Compact Flash (due to u-boot default bootargs).

I did not succeed to run under emulator to try to figure out what's going wrong.
I do not succeed to activate break points with the command (under gdb)
monitor bps do_bootm hw

Is this U-boot behaviour normal?

A second question is :
What is the starting point to have I2C EEPROM available on that ML403 board under U-boot to save environnement and us autostart?

Kinds regards

Chris

#1 lore raw
Quoted 2 lines · In message <[email protected]> you wrote:

Is this U-boot behaviour normal?

This is not "U-Boot behaviour", it is a problem with your Linux kernel.

Quoted 2 lines

What is the starting point to have I2C EEPROM available on that ML403 board under U-boot to save environnement and us autostart?

Enable I2C support in the board config file?

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
To understand a program you must become  both  the  machine  and  the
program.