hda: DMA timeout error
Dear List,
could someone knowledgeable please comment on this ?
I had a working raid-1 setup(tm) with two western digital drives being connected to a via and a highpoint controller. Now all I did is to replace ide disks (now hitachi) and suddenly I frequently see disks (on one of the controllers, sometimes hda sometimes hde) to plop out:
hda: lost interrupt
hda: dma_timer_expiry: dma status == 0x21
hda: DMA timeout error
hda: dma timeout error: status=0x58 { DriveReady SeekComplete DataRequest }
ide: failed opcode was: unknown
raid1: Disk failure on hda, disabling device.
Operation continuing on 1 devices
hda: dma_timer_expiry: dma status == 0x21
hda: DMA timeout error
hda: dma timeout error: status=0x58 { DriveReady SeekComplete DataRequest }
ide: failed opcode was: unknown
RAID1 conf printout:
--- wd:1 rd:2
disk 0, wo:1, o:0, dev:hda
disk 1, wo:0, o:1, dev:hde
RAID1 conf printout:
--- wd:1 rd:2
disk 1, wo:0, o:1, dev:hde
I simply don't understand what's wrong ... when I hot remove the drive turn on DMA and hot add the drive everything is fine again ... could one increase timeouts or try some more mature driver which has some more error recovery ? This is on kernel 2.6.17.13 ... 2.6.18 refuses to boot (kills the hotplug process repeatedly claiming the machine ran out of memory).
Any thoughts ?
Soeren
Signature · 2 lines
For the one fact about the future of which we can be certain is that it will be utterly fantastic. -- Arthur C. Clarke, 1962