hwmon: Fix documentation typos
Subsystems (2)
PATCH 3/8 hwmon: Fix documentation typos
From: Jean Delvare <khali at linux-fr.org>
Fix typos in hardware monitoring documentation.
Signed-off-by Jean Delvare <khali at linux-fr.org>
Signed-off-by Greg Kroah-Hartman <gregkh at suse.de>
--- Documentation/hwmon/f71805f | 2 +- Documentation/hwmon/w83627ehf | 6 +++--- 2 files changed, 4 insertions(+), 4 deletions(-)
Documentation/hwmon/f71805f +1 -1
@@ -17,7 +17,7 @@ Thanks to Kris Chen from Fintek for answ providing additional documentation. Thanks to Chris Lin from Jetway for providing wiring schematics and -anwsering technical questions. +answering technical questions. Description
Documentation/hwmon/w83627ehf +3 -3
@@ -26,7 +26,7 @@ fan control mode). Temperatures are measured in degrees Celsius and measurement resolution is 1 degC for temp1 and 0.5 degC for temp2 and temp3. An alarm is triggered when the temperature gets higher than high limit; it stays on until the temperature -falls below the Hysteresis value. +falls below the hysteresis value. Fan rotation speeds are reported in RPM (rotations per minute). An alarm is triggered if the rotation speed has dropped below a programmable limit. Fan
@@ -67,9 +67,9 @@ Thermal Cruise mode If the temperature is in the range defined by: -pwm[1-4]_target - set target temperature, unit millidegree Celcius +pwm[1-4]_target - set target temperature, unit millidegree Celsius (range 0 - 127000) -pwm[1-4]_tolerance - tolerance, unit millidegree Celcius (range 0 - 15000) +pwm[1-4]_tolerance - tolerance, unit millidegree Celsius (range 0 - 15000) there are no changes to fan speed. Once the temperature leaves the interval, fan speed increases (temp is higher) or decreases if lower than desired.
Signature · 1 line
1.4.2.4