Skip to contentSkip to conversation

"cloning" from ide to sata drive, can't find root

linux-lvm [email protected] 2 participants 2 messages Oct 30, 2006

lore
Share & tools
lore
#0 lore raw

I did a straight up mirroring of a drive doing dd if=/dev/hda of=/dev/sda where the src is an ide drive and target a sata drive and not unexpectedly it can't find the root device on boot.

Typing out the error message ...

[snip]
Reading all physical volumes this may take a while ... No volume groups found
Unable to find Volume Group "VolGroup00" [snip]

I used a rescue disc distro and used dd to extract info subtible for vgcfgrestore,
after which I did some other finagaling with vgchange and I can mount the volume and view the data on it, so it's there, vgscan/pvscan and lvscan all show it ... but as mentioned boot it's just not picked up on boot so it can be mounted as '/'. I thought I fixed it with the vgcfgrestore (changing /dev/hda2 to /dev/sda2) but obviously not ... any guidance is appreciated.

thank you,
brian

#1 lore raw
Quoted 20 lines · On 10/30/06, [email protected] <[email protected]> wrote:

I did a straight up mirroring of a drive doing dd if=/dev/hda of=/dev/sda where the src is an ide drive and target a sata drive and not unexpectedly it can't find the root device on boot.

Typing out the error message ...

[snip]
Reading all physical volumes this may take a while ... No volume groups found
Unable to find Volume Group "VolGroup00" [snip]

I used a rescue disc distro and used dd to extract info subtible for vgcfgrestore,
after which I did some other finagaling with vgchange and I can mount the volume and view the data on it, so it's there, vgscan/pvscan and lvscan all show it ... but as mentioned boot it's just not picked up on boot so it can be mounted as '/'. I thought I fixed it with the vgcfgrestore (changing /dev/hda2 to /dev/sda2) but obviously not ... any guidance is appreciated.

Quoted 2 lines

thank you,
brian

Ignoring LVM issues, I believe I've done this in the past with traditional partitions. IIRC, all I did was add a root=/dev/sdaX parameter on my grub boot command line, and then use that to boot single-user mode and edit my /etc/fstab to reference the correct device.

Not sure how LVM would change that.

FYI: I personally don't use LVM on my boot and root partitions.

Greg

Signature · 3 lines
Greg Freemyer
The Norcross Group
Forensics for the 21st Century