A raid in a raid.
Hi,
I have a raid array setup with 6 sata drives (500gb) and 4 ide drives (250gb). My intention was to setup the disks as follows. Personalities : [raid0] [raid6] [raid5] [raid4]
md2 : active raid6 md1[6](S) md0[7] sda[0] sdf[5] sde[4] sdd[3] sdc[2] sdb[1]
2930318976 blocks level 6, 64k chunk, algorithm 2 [8/6] [UUUUUU__]
[>....................] recovery = 0.0% (249556/488386496)finish=880.0min speed=9242K/sec
md1 : active raid0 hdh[0] hdc[1]
488396928 blocks 64k chunks
md0 : active raid0 hde[0] hdb[1]
488396928 blocks 64k chunks
unused devices: <none>
All works well until a system reboot. md2 appears to be brought up before md0 and md1 which causes the raid to start without two of its drives.
Is there anyway to fix this?
Signature · 2 lines
View this message in context: http://www.nabble.com/A-raid-in-a-raid.-tf4117582.html#a11709647 Sent from the linux-raid mailing list archive at Nabble.com.
mullaly wrote:
[]
Quoted 4 lines
All works well until a system reboot. md2 appears to be brought up before md0 and md1 which causes the raid to start without two of its drives.
Is there anyway to fix this?
How about listing the arrays in proper order in mdadm.conf ?
/mjt