Skip to contentSkip to conversation

Problem with the tc statistcis

LARTC Christian Benvenuti 1 participant 1 message May 26, 2007

lore
Share & tools
lore
#0 lore raw

Hi Yang,

Quoted 3 lines

I had a linux wireless router. I would like to monitor the queue lengh of the wireless interface. By default, the wifi0 interface is with pfifo_fast qdisc which does not report backlog packet.

Actually it does:

# tc -s -d qdisc list dev eth1

qdisc pfifo_fast root bands 3 priomap 1 2 2 2 1 2 0 0 1 1 1 1 1 1 1 1
Sent 256404346 bytes 246076 pkt (dropped 0, overlimits 0 requeues 0) rate 0bit 0pps backlog 27092b 26p requeues 0

                ^^^^^^^^^^^^^^^^^^

If the counters are set to 0 it is probably because there is no backlog (i.e., you transmit faster than you queue).

Quoted 6 lines

I replaced
pfifo_fast with pfifo:
'tc qdisc replace dev wifi0 root pfifo'
Then I use iperf to send UDP pkts faster than the interface can handle but when I read the qdisc, the result is like:

Quoted 6 lines

qdisc pfifo 8007: limit 10p
Sent 46249560 bytes 30600 pkts (dropped 0, overlimits 0)

It is really strange, because over 80% of packets lost is observed by application layer but by qdisc, there is no packet dropped at all and no backlog. Any hints for this result?

Are you sure it is not the application that drops the packets? Did you check the "bytes/pkt" counters on the tx and rx hosts?

Regards
/Christian
(http://benve.info)

_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc