Problem: how to use kernel and cross-compiler that already exist
Hello EveryOne:
I have a kernel and cross-compiler for a special device . and I
want to run openmoko on that device .
so the best way is use the exist tool to compile it ! I notice that OE auto fetch and compile cross tool .but think this :
My target device use glibc2.3.3 gcc 3.3.4 .so i change .conf file
to this . But It can't pass . Lots of error occur when do_configure and do_build . so use exist tool is the only way i can go !
how ?
Best wishes
Tongfeng.Yang
Re: Problem: how to use kernel and cross-compiler that alreadyexist
Check the wiki on using external toolchains with OE
Stelios S. Koroneos
Digital OPSiS - Embedded Intelligence
http://www.digital-opsis.com
Quoted 32 lines
-----Original Message-----
From: [email protected] [mailto:[email protected]]On Behalf Of Tongfeng.Yang
Sent: Thursday, August 30, 2007 5:18 AM
To: [email protected]
Subject: [oe] Problem: how to use kernel and cross-compiler that alreadyexistHello EveryOne:
I have a kernel and cross-compiler for a special device . and I
want to run openmoko on that device .
so the best way is use the exist tool to compile it ! I notice that OE auto fetch and compile cross tool .but think this :
My target device use glibc2.3.3 gcc 3.3.4 .so i change .conf file
to this . But It can't pass . Lots of error occur whendo_configureanddo_build. so use exist tool is the only way i can go !how ?
Best wishes
Tongfeng.Yang
_______________________________________________
Openembedded-devel mailing list
[email protected]
http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/openembedded-devel