Skip to contentSkip to conversation

load balance switching latency

LARTC Alec Joseph Rivera 1 participant 1 message Oct 12, 2007

lore
Share & tools
lore
#0 lore raw

Hello there.

I am setting up a router using openwrt. Part of the project is load balancing among 2 broadband lines. I made use of the line:

ip route add default scope global \

	nexthop {GW1} dev {IF1} weight 1 \
	nexthop {GW2} dev {IF2} weight 1

somewhere on the configs.

On the test phase, automatically switching (routing) to line GW2 when line GW1 is suddenly disconnected takes a long time. I'm thinking that the routing still tries to send to GW1 even though it's dead.

a. Is there a way around this?
b. Does routing react differently to carrier loss (unplugging the cable) to a fully loaded line?

Any thoughts? Thanks...

Signature · 3 lines
Alec Joseph Rivera
F S 3 Consulting Inc.
http://www.fs3.ph

_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc