Usage of network service

Hello,

I've been using bluetooth PAN using pand daemon. Pand runs as a daemon and used to create network interface on demand calling dev-up and dev-down script which in turn runs ifup and ifdown to setup the device.

In newer version of bluez, it's preffered to use network service, but I haven't found any documentation describing the process of creating and setting up the device.

It is right that network service creates device and calls upon them ifup/ifdown or does some dbus (HAL, NetworkManager) magic?

Regards

Mila

-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php

_______________________________________________
Bluez-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-users

I'm quite suprised that no one is using PAN network service...

-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace

_______________________________________________
Bluez-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-users