regulator: kbuild
PATCH v3 6/7 regulator: kbuild
This patch adds Makefile and Kconfig for regulator core.
Signed-off-by Liam Girdwood <[email protected]>
--- drivers/Kconfig | 2 ++ drivers/Makefile | 1 + drivers/regulator/Kconfig | 32 ++++++++++++++++++++++++++++++++ drivers/regulator/Makefile | 7 +++++++ 4 files changed, 42 insertions(+), 0 deletions(-) create mode 100644 drivers/regulator/Kconfig create mode 100644 drivers/regulator/Makefile
drivers/Kconfig +2 -0
@@ -90,6 +90,8 @@ source "drivers/edac/Kconfig" source "drivers/rtc/Kconfig" +source "drivers/regulator/Kconfig" + source "drivers/dma/Kconfig" source "drivers/dca/Kconfig"
drivers/Makefile +1 -0
@@ -86,6 +86,7 @@ obj-y += firmware/ obj-$(CONFIG_CRYPTO) += crypto/ obj-$(CONFIG_SUPERH) += sh/ obj-$(CONFIG_GENERIC_TIME) += clocksource/ +obj-$(CONFIG_REGULATOR) += regulator/ obj-$(CONFIG_DMA_ENGINE) += dma/ obj-$(CONFIG_DCA) += dca/ obj-$(CONFIG_HID) += hid/
drivers/regulator/Kconfig new file +32 -0
@@ -0,0 +1,32 @@ +menu "Voltage and Current regulators" + +config REGULATOR + bool "Voltage and Current Regulator Support" + default n + help + Generic Voltage and Current Regulator support. + + This framework is designed to provide a generic interface to voltage + and current regulators within the Linux kernel. It's intended to + provide voltage and current control to client or consumer drivers and + also provide status information to user space applications through a + sysfs interface. + + The intention is to allow systems to dynamically control regulator + output in order to save power and prolong battery life. This applies + to both voltage regulators (where voltage output is controllable) and + current sinks (where current output is controllable). + + This framework safely compiles out if not selected so that client + drivers can still be used in systems with no software controllable + regulators. + + If unsure, say no. + +config REGULATOR_DEBUG + bool "Regulator debug support" + depends on REGULATOR + help + Say yes here to enable debugging support. + +endmenu
drivers/regulator/Makefile new file +7 -0
@@ -0,0 +1,7 @@ +# +# Makefile for regulator drivers. +# + +obj-$(CONFIG_REGULATOR) += reg-core.o + +ccflags-$(CONFIG_REGULATOR_DEBUG) += -DDEBUG
Signature · 1 line
1.5.4.3