mfd: add clock API support to asic3 using clocklib
RFC PATCH 1/1 mfd: add clock API support to asic3 using clocklib
This patch adds basic clock API support for ASIC3 clocks using Dmitry Baryshkov's clocklib (http://lkml.org/lkml/2008/6/26/278).
The CDEX clocks can be enabled/disabled and the SD host and bus clock rates can be changed. Also the clock settings comment for SD HCLK and BCLK in asic3.h is moved to the right place.
I am missing information about the spi, pwm, led, smbus and cx clock's rates, and I'm not sure if the SOURCE0/1 bits in CLOCK_CDEX should be handled here somehow. The CLOCK_SEL_CX bit in CLOCK_SEL is only used internally by the IRQ controller, so I guess not handling that is fine.
Signed-off-by Philipp Zabel <[email protected]>
--- drivers/mfd/Kconfig | 2 +- drivers/mfd/asic3.c | 146 ++++++++++++++++++++++++++++++++++++++++++++- include/linux/mfd/asic3.h | 2 +- 3 files changed, 147 insertions(+), 3 deletions(-)
drivers/mfd/Kconfig +1 -1
@@ -17,7 +17,7 @@ config MFD_SM501 config MFD_ASIC3 bool "Support for Compaq ASIC3" - depends on GENERIC_HARDIRQS && HAVE_GPIO_LIB && ARM + depends on GENERIC_HARDIRQS && HAVE_GPIO_LIB && HAVE_CLOCKLIB && ARM ---help--- This driver supports the ASIC3 multifunction chip found on many PDAs (mainly iPAQ and HTC based ones)
drivers/mfd/asic3.c +145 -1
186 lines not on this page · raw message
include/linux/mfd/asic3.h +1 -1
@@ -152,7 +152,6 @@ struct asic3_platform_data {#define CLOCK_CDEX_LED1 (1 << 7)#define CLOCK_CDEX_LED2 (1 << 8) -/* Clocks settings: 1 for 24.576 MHz, 0 for 12.288Mhz */ #define CLOCK_CDEX_SD_HOST (1 << 9)/* R/W: SD host clock source */ #define CLOCK_CDEX_SD_BUS (1 << 10)/* R/W: SD bus clock source ctrl */ #define CLOCK_CDEX_SMBUS (1 << 11)
@@ -161,6 +160,7 @@ struct asic3_platform_data {#define CLOCK_CDEX_EX0 (1 << 13)/* R/W: 32.768 kHz crystal */ #define CLOCK_CDEX_EX1 (1 << 14)/* R/W: 24.576 MHz crystal */ +/* Clocks settings: 1 for 24.576 MHz, 0 for 12.288Mhz */ #define CLOCK_SEL_SD_HCLK_SEL (1 << 0)/* R/W: SDIO host clock select */ #define CLOCK_SEL_SD_BCLK_SEL (1 << 1)/* R/W: SDIO bus clock select */
Signature · 1 line
1.5.5.4