Skip to contentSkip to conversation

net/usb: catc.c - place dev_err instead of err()

PATCH In review Alexey Klimov 2 participants 2 messages Jan 11, 2009 1 message not in the archive

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/3 net/usb: catc.c - place dev_err instead of err()

Hello,

there are 3 patches for usb-network drivers that use err macroses.

Probably, few mistakes exist in this 3 patches and they should be reformatted. May be they should be joined in one patch. Please, review.

---
Remove err-messages and place dev_err there.

--

drivers/net/usb/catc.c +8 -8
index cb7acbb..e23fa80 100644
@@ -339,14 +339,14 @@ static void catc_irq_done(struct urb *urb)
 		} else {
 			catc->rx_urb->dev = catc->usbdev;
 			if ((res = usb_submit_urb(catc->rx_urb, GFP_ATOMIC)) < 0) {
-				err("submit(rx_urb) status %d", res);
+				dev_err(&urb->dev->dev, "submit(rx_urb) status %d\n", res);
 			}
 		} 
 	}
 resubmit:
 	res = usb_submit_urb (urb, GFP_ATOMIC);
 	if (res)
-		err ("can't resubmit intr, %s-%s, status %d",
+		dev_err(&urb->dev->dev,"can't resubmit intr, %s-%s, status %d\n",
 				catc->usbdev->bus->bus_name,
 				catc->usbdev->devpath, res);
 }
@@ -367,7 +367,7 @@ static int catc_tx_run(struct catc *catc)
 	catc->tx_urb->dev = catc->usbdev;
 
 	if ((status = usb_submit_urb(catc->tx_urb, GFP_ATOMIC)) < 0)
-		err("submit(tx_urb), status %d", status);
+		dev_err(&catc->usbdev->dev, "submit(tx_urb), status %d\n", status);
 
 	catc->tx_idx = !catc->tx_idx;
 	catc->tx_ptr = 0;
@@ -496,7 +496,7 @@ static void catc_ctrl_run(struct catc *catc)
 		memcpy(catc->ctrl_buf, q->buf, q->len);
 
 	if ((status = usb_submit_urb(catc->ctrl_urb, GFP_KERNEL)))
-		err("submit(ctrl_urb) status %d", status);
+		dev_err(&usbdev->dev, "submit(ctrl_urb) status %d\n", status);
 }
 
 static void catc_ctrl_done(struct urb *urb)
@@ -555,7 +555,7 @@ static int catc_ctrl_async(struct catc *catc, u8 dir, u8 request, u16 value,
 	catc->ctrl_head = (catc->ctrl_head + 1) & (CTRL_QUEUE - 1);
 
 	if (catc->ctrl_head == catc->ctrl_tail) {
-		err("ctrl queue full");
+		dev_err(&catc->usbdev->dev, "ctrl queue full\n");
 		catc->ctrl_tail = (catc->ctrl_tail + 1) & (CTRL_QUEUE - 1);
 		retval = -1;
 	}
@@ -721,7 +721,7 @@ static int catc_open(struct net_device *netdev)
 
 	catc->irq_urb->dev = catc->usbdev;
 	if ((status = usb_submit_urb(catc->irq_urb, GFP_KERNEL)) < 0) {
-		err("submit(irq_urb) status %d", status);
+		dev_err(&netdev->dev, "submit(irq_urb) status %d\n", status);
 		return -1;
 	}
 
@@ -764,7 +764,7 @@ static int catc_probe(struct usb_interface *intf, const struct usb_device_id *id
 
 	if (usb_set_interface(usbdev,
 			intf->altsetting->desc.bInterfaceNumber, 1)) {
-                err("Can't set altsetting 1.");
+                dev_err(&intf->dev, "Can't set altsetting 1.\n");
 		return -EIO;
 	}
 
@@ -799,7 +799,7 @@ static int catc_probe(struct usb_interface *intf, const struct usb_device_id *id
 	catc->irq_urb = usb_alloc_urb(0, GFP_KERNEL);
 	if ((!catc->ctrl_urb) || (!catc->tx_urb) || 
 	    (!catc->rx_urb) || (!catc->irq_urb)) {
-		err("No free urbs available.");
+		dev_err(&intf->dev, "No free urbs available.\n");
 		usb_free_urb(catc->ctrl_urb);
 		usb_free_urb(catc->tx_urb);
 		usb_free_urb(catc->rx_urb);
Signature · 1 line
Best regards, Klimov Alexey
#2 lore raw
In reply to a message not in the archive
Quoted 2 lines · Alexey Klimov

-                               err("submit(rx_urb) status %d", res);
+                               dev_err(&urb->dev->dev, "submit(rx_urb) status %d\n", res);

You should really find and use the device on the *interface* to which that driver is bound, rather than the one in the URB. That's what gets passed in to probe(); drivers normally remember that until a remove() callback unbinds the driver from that interface.

A weak analogy is issuing a diagnostic about the PCI bus to which the PCI device is attached, instead of the PCI device itself. In both cases, the diagnostic would point to the wrong thing...

The other two patches got this right in at least some cases, but I didn't look in any detail.

- Dave

--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html