w1_ds2433: clear the validcrc flag after a write
PATCH 1/1 w1_ds2433: clear the validcrc flag after a write
The w1_ds2433 driver does not read from the hardware if the CRC was valid on the last read. The validcrc flag should be cleared after a write so that the new value can be read.
Signed-off-by Ben Gardner <[email protected]>
Signed-off-by Evgeniy Polyakov <[email protected]>
drivers/w1/slaves/w1_ds2433.c +6 -1
@@ -156,6 +156,9 @@*/ static int w1_f23_write (struct w1_slave *sl,int addr,int len,const u8 *data) { +#ifdef CONFIG_W1_SLAVE_DS2433_CRC +struct w1_f23_data *f23 = sl->family_data; +#endif u8 wrbuf[4 ];u8 rdbuf[W1_PAGE_SIZE +3 ];u8 es = (addr + len -1 ) &0x1f ;
@@ -196,7 +199,9 @@/* Reset the bus to wake up the EEPROM (this may not be needed) */ w1_reset_bus (sl->master); - +#ifdef CONFIG_W1_SLAVE_DS2433_CRC + f23->validcrc &= ~(1 << (addr >>W1_PAGE_BITS )); +#endif return 0 ; }