Skip to contentSkip to conversation

threaded interrupt handler support breaks (some) irq handling on AVR32

REGRESSION Ben Nizette 1 participant 1 message Apr 14, 2009

lore
Share & tools
lore
#0 lore raw

[cc'ing *correct* lkml address]

After pulling in Linus' latest this morning, a tap on the touchscreen of my AVR32-based board caused the system to hang hard. It's an ads7843 touchscreen controller driven by drivers/input/touchscreen/ads7846.c - the tap triggers a pen-down IRQ. Note that I made a small mod to that driver; due to limitations of the AVR32's gpio interrupt controller I have to do

@@ -1129,7 +1129,7 @@ static int __devinit ads7846_probe(struct spi_device *spi)

        ts->last_msg = m;

- if (request_irq(spi->irq, ads7846_irq, IRQF_TRIGGER_FALLING,
+ if (request_irq(spi->irq, ads7846_irq, IRQF_TRIGGER_FALLING | IRQF_TRIGGER_RISING,

                        spi->dev.driver->name, ts)) {
                dev_dbg(&spi->dev, "irq %d busy?\n", spi->irq);
                err = -EBUSY;

This doesn't effect the driver operation as the irq handler checks the logic level of the line anyway.

I've bisected the problem to

commit 3aa551c9b4c40018f0e261a178e3d25478dc04a9

Author: Thomas Gleixner <[email protected]>
Date:   Mon Mar 23 18:28:15 2009 +0100

genirq: add threaded interrupt handler support

Add support for threaded interrupt handlers:

Because this doesn't revert cleanly I did the bisection again just to be sure and it came out the same.

Just before the hang,
~ # cat /proc/interrupts
CPU0

  0:         42      intc  avr32_comparator
  1:          0      intc  atmel_lcdfb
  2:          1      intc  dw_dmac
  4:          4      intc  atmel_spi.1
  9:        555      intc  ttyS0
 21:          0      intc  rtc
 22:      34037      intc  tc_clkevt
 24:          0      intc  atmel_pwm
 25:       2439      intc  eth0
 28:        156      intc  atmel_mci.0
 31:          0      intc  atmel_usba_udc
131:          0      gpio  ads7846

Note it's that very last line which, when triggered, causes the hang. As you can see, it's the only one connected through the gpio interrupt chip.

No sysrq action is possible because of the limited kinds of terminals I can attach to this board.

Given the limited scope for debug (no logs or sysrq output available) I can't think exactly what more I can tell you to help you get to the bottom of it. I'll do whatever I can though, it's perfectly repeatable.

Thanks,

	--Ben.