Skip to contentSkip to conversation

2.6.29 CCISS Problem

DISCUSSION Mr Blogs 1 participant 1 message Apr 15, 2009

lore
Share & tools
lore

Mr Blogs

author
#0 lore raw

I am using Gentoo on a HP DL380 G3. Intel Xeon (P4) 3.06ghz processors,
with a HP COMPAQ CCISS ARRAY in RAID 0 mode (hardware, linux just sees one single drive)

hdparm on 2.6.27 shows the speed at ~ 130mbs

After performing an upgrade of the kernel

hdparm on 2.6.29 shows the speed at ~ 30mbs (30-50mbs varies)

I looked at the DMESG comparisons,
and the only difference is that 2.6.29 mentions:
"IRQF_DISABLED is not guaranteed on shared IRQs"

Now I have looked for hours to see if it was a configuration issue, but to no avail.

Yes the 2.6.27 kernel was self built, and it works fine. The 2.6.29 was built using the .config file from the 2.6.27.

I compiled this kernel on two servers, both same spec (well, one has 4GB ram other has 2GB ram), same setup - and both responded as above.

On the one, I recompiled the kernel to just use the new version (NO config changes). The other I re-compiled using config changes (removing things not relevant for the machine etc) - both end up having this problem.

I have done a "diff" compare on the configs, but there is nothing I can find that would explain this.

I know that this "IRQF_DISABLED" warning isn't present in 2.6.27 boots, and that the CISS driver works full speed in that one.

I thought it was originally that I changed the IO Scheduling, but as i said, on the one machine - all i did was copy the config file and recompile.

Do you know of anything that could be causing this?

I checked proc/interrupts on both kernel versions, and IRQ 30 is unshared (IO-APIC-FASTEOI cciss or something like that), i am just unsure what is causing the issue.

Thankyou.

Signature · 6 lines
  Mr Blogs
  [email protected]

-- 
http://www.fastmail.fm - Accessible with your email software
                          or over the web