dmaengine/async_tx update for 2.6.31-rc5
Dan Williams
Acked-by Timur Tabi Acked-by Kumar Gala Acked-by Maciej Sosnowski Acked-by Haavard Skinnemoen Acked-by Maciej Sosnowski Acked-by Maciej SosnowskiHi Linus, please pull from:
git://git.kernel.org/pub/scm/linux/kernel/git/djbw/async_tx.git next
...to receive:
Dan Williams (1):
dmaengine: move HIGHMEM64G restriction to ASYNC_TX_DMA
Ira Snyder (2):
fsldma: enable external start for the 83xx controller
fsldma: do not clear bandwidth control bits on the 83xx controller
Ira W. Snyder (1):
fsldma: use PCI Read Multiple command
Joe Perches (2):
drivers/dma/fsldma.c: Remove unnecessary semicolons drivers/dma: Remove unnecessary semicolons
Nicolas Ferre (4):
dmaengine: dmatest: add a maximum number of test iterations
dmaengine: dmatest: correct thread_count while using multiple thread per channel
dmaengine: at_hdmac: new driver for the Atmel AHB DMA Controller
dmaengine: at_hdmac: add DMA slave transfers
arch/arm/mach-at91/include/mach/at_hdmac.h | 102 +++ crypto/async_tx/async_xor.c | 2 +- drivers/dma/Kconfig | 12 +- drivers/dma/Makefile | 1 + drivers/dma/at_hdmac.c | 1213 ++++++++++++++++++++++++++++ drivers/dma/at_hdmac_regs.h | 353 ++++++++ drivers/dma/dmatest.c | 21 +- drivers/dma/fsldma.c | 17 +- drivers/dma/fsldma.h | 1 + drivers/dma/mv_xor.c | 2 +- 10 files changed, 1711 insertions(+), 13 deletions(-) create mode 100644 arch/arm/mach-at91/include/mach/at_hdmac.h create mode 100644 drivers/dma/at_hdmac.c create mode 100644 drivers/dma/at_hdmac_regs.h
These patches have had exposure in linux-next and include:
1/ Some fsldma fixups from Ira that I have been sitting on for too long
2/ A loosening of the Kconfig dependencies for the DMADEVICES menu.
3/ A new dma driver from Nicolas, with some fixes to dmatest.
4/ Some trivial cleanups from Joe.
Thanks,
Dan
commit a7aea373b4ca428f1be2c1fedd2f26c8e3f2864d
Author: Ira W. Snyder <[email protected]> Date: Thu Apr 23 16:17:54 2009 -0700
fsldma: use PCI Read Multiple command
By default, the Freescale 83xx DMA controller uses the PCI Read Line command when reading data over the PCI bus. Setting the controller to use the PCI Read Multiple command instead allows the controller to read much larger bursts of data, which provides a drastic speed increase.
The slowdown due to using PCI Read Line was only observed when a PCI-to-PCI bridge was between the devices trying to communicate.
A simple test driver showed an increase from 4MB/sec to 116MB/sec when performing DMA over the PCI bus. Using DMA to transfer between blocks of local SDRAM showed no change in performance with this patch. The dmatest driver was also used to verify the correctness of the transfers, and showed no errors.
commit be30b226f2ae618cd719e40267d9923db1db9001
Author: Ira Snyder <[email protected]> Date: Thu May 28 09:20:42 2009 +0000
fsldma: enable external start for the 83xx controller
The 83xx controller has external start capability, but lacks external pause capability. Hook up the external start function pointer for the 83xx controller.
commit 43a1a3ed6bf5a1b9ae197b4f5f20033baf19db61
Author: Ira Snyder <[email protected]> Date: Thu May 28 09:26:40 2009 +0000
fsldma: do not clear bandwidth control bits on the 83xx controller
The 83xx controller does not support the external pause feature. The bit in the mode register that controls external pause on the 85xx controller happens to be part of the bandwidth control settings for the 83xx controller.
This patch fixes the driver so that it only clears the external pause bit if the hardware is the 85xx controller. When driving the 83xx controller, the bit is left untouched. This follows the existing convention that mode registers settings are not touched unless necessary.
commit daf4219dbcbb2efcd638fcd3c29a622e1c18cc38
Author: Dan Williams <[email protected]> Date: Wed Jul 1 16:12:53 2009 -0700
dmaengine: move HIGHMEM64G restriction to ASYNC_TX_DMA
On HIGHMEM64G systems dma_addr_t is known to be larger than (void *) which precludes async_xor from performing dma address conversions by reusing the input parameter address list. However, other parts of the dmaengine infrastructure do not suffer this constraint, so the HIGHMEM64G restriction can be down-levelled.
commit e3d433040ee6077e33d4ad22e2f60a38b085786d
Author: Joe Perches <[email protected]> Date: Sun Jun 28 09:26:20 2009 -0700
drivers/dma/fsldma.c: Remove unnecessary semicolons
commit c019894efc9c9ba5939948caa78c133b1ec8ae63
Author: Joe Perches <[email protected]> Date: Sun Jun 28 09:26:21 2009 -0700
drivers/dma: Remove unnecessary semicolons
commit 0a2ff57d6fba92842272889b4bca447344cd9d36
Author: Nicolas Ferre <[email protected]> Date: Fri Jul 3 19:26:51 2009 +0200
dmaengine: dmatest: add a maximum number of test iterations
The dmatest usually waits for the killing of its kthreads to stop running tests. This patch adds a parameter that sets a maximum number of test iterations.
This feature is quite interesting for debugging when you set a lot of traces in your dmaengine controller driver.
commit f1aef8b6e6abf32a3a269542f95a19e2cb319f6c
Author: Nicolas Ferre <[email protected]> Date: Mon Jul 6 18:19:44 2009 +0200
dmaengine: dmatest: correct thread_count while using multiple thread per channel
It seems that thread_count is not properly calculated in dmatest. In fact the thread count number that is returned from dmatest_add_threads() is not correctly added to the thread_count and thus not properly printed.
commit dc78baa2b90b289590911b40b6800f77d0dc935a
Author: Nicolas Ferre <[email protected]> Date: Fri Jul 3 19:24:33 2009 +0200
dmaengine: at_hdmac: new driver for the Atmel AHB DMA Controller
This AHB DMA Controller (aka HDMA or DMAC on AT91 systems) is availlable on at91sam9rl chip. It will be used on other products in the future.
This first release covers only the memory-to-memory tranfer type. This is the only tranfer type supported by this chip. On other products, it will be used also for peripheral DMA transfer (slave API support to come).
I used dmatest client without problem in different configurations to test it.
Full documentation for this controller can be found in the SAM9RL datasheet:
http://www.atmel.com/dyn/products/product_card.asp?part_id=4243
commit 808347f6a31792079e345ec865e9cfcb6e8ae6b2
Author: Nicolas Ferre <[email protected]> Date: Wed Jul 22 20:04:45 2009 +0200
dmaengine: at_hdmac: add DMA slave transfers
This patch for at_hdmac adds the slave transfers capability to the Atmel DMA controller available on some AT91 SOCs. This allow peripheral to memory and memory to peripheral transfers with hardware handshaking.
Slave structure for controller specific information is passed through channel private data. This at_dma_slave structure is defined in at_hdmac.h header file and relative hardware definition are moved to this file from at_hdmac_regs.h. Doing this we allow the channel configuration from platform definition code.
This work is intensively based on dw_dmac and several slave implementations.