Kirkwood: Marvell OpenRD-Client board support added
Subsystems (2)
PATCH 1/1 Kirkwood: Marvell OpenRD-Client board support added
reference:
http://open-rd.org
http://code.google.com/p/openrd
This patch is tested for:
1. Boot from DRAM/NAND flash
2. NAND read/write/erase
3. GbE0 & GbE1
4. USB read/write
5. SATA
FIXME:
1. SD/UART1 selection
2. MPP configuration (currently, default)
3. PEX
4. Audio
5. VGA
Signed-off-by Dhaval Vasa <[email protected]>
--- arch/arm/mach-kirkwood/Kconfig | 6 ++ arch/arm/mach-kirkwood/Makefile | 1 + arch/arm/mach-kirkwood/openrd_client-setup.c | 92 ++++++++++++++++++++++++++ 3 files changed, 99 insertions(+), 0 deletions(-) create mode 100644 arch/arm/mach-kirkwood/openrd_client-setup.c
arch/arm/mach-kirkwood/Kconfig +6 -0
@@ -43,6 +43,12 @@ config MACH_OPENRD_BASE help Say 'Y' here if you want your kernel to support the Marvell OpenRD Base Board. + +config MACH_OPENRD_CLIENT + bool "Marvell OpenRD Client Board" + help + Say 'Y' here if you want your kernel to support the + Marvell OpenRD Client Board. endmenu endif
arch/arm/mach-kirkwood/Makefile +1 -0
@@ -7,5 +7,6 @@ obj-$(CONFIG_MACH_MV88F6281GTW_GE) += mv88f6281gtw_ge-setup.o obj-$(CONFIG_MACH_SHEEVAPLUG) += sheevaplug-setup.o obj-$(CONFIG_MACH_TS219) += ts219-setup.o obj-$(CONFIG_MACH_OPENRD_BASE) += openrd_base-setup.o +obj-$(CONFIG_MACH_OPENRD_CLIENT) += openrd_client-setup.o obj-$(CONFIG_CPU_IDLE) += cpuidle.o
arch/arm/mach-kirkwood/openrd_client-setup.c new file +92 -0
92 lines not on this page · raw message
Signature · 18 lines
1.6.3.3 -- _____________________________________________________________________ Disclaimer: This e-mail message and all attachments transmitted with it are intended solely for the use of the addressee and may contain legally privileged and confidential information. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, copying, or other use of this message or its attachments is strictly prohibited. If you have received this message in error, please notify the sender immediately by replying to this message and please delete it from your computer. Any views expressed in this message are those of the individual sender unless otherwise stated.Company has taken enough precautions to prevent the spread of viruses. However the company accepts no liability for any damage caused by any virus transmitted by this email. _____________________________________________________________________