Skip to contentSkip to conversation

OMAP reaction facing a multiple devices definition by muxing

DISCUSSION max 2 participants 2 messages Oct 30, 2009

lore
Share & tools
lore

max

author
#0 lore raw

Hello,

I have a question concerning the mux and the OMAP's reaction.

How does the omap reacts when you define a register for a specific device that is already initiated as primary mode of another register ? For example CONTROL_PADCONF_UART1_ defines the uart1 in primary mode but when you mux the register CONTROL_PADCONF_MCBSP_CLKS into mode 5 (and the other apropiate registers for the uart1) how does the OMAP reacts ?

Thank you for your answer.

Best regard,

Maxime Bouré

--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html

#1 lore raw
Quoted 11 lines · max

Hello,

I have a question concerning the mux and the OMAP's reaction.

How does the omap reacts when you define a register for a specific device that is already initiated as primary mode of another register ? For example CONTROL_PADCONF_UART1_ defines the uart1 in primary mode but when you mux the register CONTROL_PADCONF_MCBSP_CLKS into mode 5 (and the other apropiate registers for the uart1) how does the OMAP reacts ?

Thank you for your answer.

AFAIK, it just reroutes the signal and that's it. The muxing system does not affect the omap internal state, it's there just to route the signals to the limited number of pins.

Regards,

Tony