musb: Add host support for DM365 EVM
A message that is not in the archive (sent off-list or not yet received): [email protected]
PATCH v2 1/1 musb: Add host support for DM365 EVM
Hi Prathap,
Please post patch updates to an existing list in the future. That would increase response times... ;-)
But nevertheless: Applied to u-boot-usb
Thanks.
Remy
2010/1/11 Prathap Srinivas <[email protected]>:
Quoted 126 lines
Add support for musb host on DM365 EVM.
Signed-off-by Prathap Srinivas <[email protected]>---
Changes from v1:
? ? ? ?- fixed review comments from Remy.?drivers/usb/musb/davinci.c ? ? ? ? | ? 21 ++++++++++++++++++- ?drivers/usb/musb/davinci.h ? ? ? ? | ? ?1 + ?include/configs/davinci_dm365evm.h | ? 38 ++++++++++++++++++++++++++++++++++++?3 files changed, 58 insertions(+), 2 deletions(-)
drivers/usb/musb/davinci.c +0
-0@@ -24,6 +24,7 @@?#include <
common.h>
?#include <asm/io.h>
?#include "davinci.h"
+#include <asm/arch/hardware.h>?/* MUSB platform configuration */
?structmusb_configmusb_cfg= {drivers/usb/musb/davinci.c +3
-1@@ -41,10 +42,25 @@ struct davinci_usb_regs *dregs; ?static u8 phy_on(void) ?{ ? ? ? ?u32 timeout; - +#ifdef DAVINCI_DM365EVM + ? ? ? u32 val; +#endif ? ? ? ?/* Wait until the USB phy is turned on */
drivers/usb/musb/davinci.c +4
-0+#ifdef DAVINCI_DM365EVM + ? ? ? writel(USBPHY_PHY24MHZ | USBPHY_SESNDEN | + ? ? ? ? ? ? ? ? ? ? ? USBPHY_VBDTCTEN, USBPHY_CTL_PADDR); +#else ? ? ? ?writel(USBPHY_SESNDEN |
USBPHY_VBDTCTEN,USBPHY_CTL_PADDR); +#endif
? ? ? ?timeout = musb_cfg.timeout;drivers/usb/musb/davinci.c +8
-0+ +#ifdef DAVINCI_DM365EVM + ? ? ? /* Set the ownership of GIO33 to USB */ + ? ? ? val = readl(PINMUX4); + ? ? ? val &= ~(PINMUX4_USBDRVBUS_BITCLEAR); + ? ? ? val |= PINMUX4_USBDRVBUS_BITSET; + ? ? ? writel(val, PINMUX4); +#endif ? ? ? ?while (timeout--)
? ? ? ? ? ? ? ?if (readl(USBPHY_CTL_PADDR)&USBPHY_PHYCLKGD) ? ? ? ? ? ? ? ? ? ? ? ?return 1;drivers/usb/musb/davinci.c +0
-0@@ -70,8 +86,9 @@ int musb_platform_init(void) ? ? ? ?u32 ?revision;? ? ? ?/* enable USB VBUS */
+#ifndefDAVINCI_DM365EVM
? ? ? ?enable_vbus();drivers/usb/musb/davinci.c +1
-1- +#endif ? ? ? ?/* start the on-chip USB phy and its pll */ ? ? ? ?if (!phy_on())
? ? ? ? ? ? ? ?return -1;drivers/usb/musb/davinci.h +0
-0@@ -63,6 +63,7 @@ struct davinci_usb_regs {?/* Integrated highspeed/otg PHY */
?#defineUSBPHY_CTL_PADDR? ? ? (DAVINCI_SYSTEM_MODULE_BASE+0x34) +#defineUSBPHY_PHY24MHZ? ? ? ?(1 << 13)
?#defineUSBPHY_PHYCLKGD? ? ? ?(1 << 8)
?#defineUSBPHY_SESNDEN? ? ? ? (1 << 7) ? ? ? ?/*v(sess_end)comparator */ ?#defineUSBPHY_VBDTCTEN? ? ? ?(1 << 6) ? ? ? ?/* v(bus) comparator */include/configs/davinci_dm365evm.h +0
-0@@ -86,6 +86,44 @@?#define
CONFIG_SYS_MAX_NAND_DEVICE? ? 1
?#defineCONFIG_SYS_NAND_MAX_CHIPS? ? ?2include/configs/davinci_dm365evm.h +38
-0+#define PINMUX4_USBDRVBUS_BITCLEAR ? ? ? 0x3000 +#define PINMUX4_USBDRVBUS_BITSET ? ? ? ? 0x2000 + +/* USB Configuration */ +#define CONFIG_USB_DAVINCI +#define CONFIG_MUSB_HCD + +#ifdef CONFIG_USB_DAVINCI +#define CONFIG_CMD_USB ? ? ? ?/* include support for usb ? ? ?*/ +#define CONFIG_CMD_STORAGE ? ?/* include support for usb ? ? ?*/ +#define CONFIG_CMD_FAT ? ? ? ?/* include support for FAT/storage*/ +#define CONFIG_DOS_PARTITION ?/* include support for FAT/storage*/ +#endif + +#ifdef CONFIG_MUSB_HCD ? ? ? ? /* include support for usb host */ +#define CONFIG_CMD_USB ? ? ? ?/* include support for usb cmd */ +#define CONFIG_USB_STORAGE ? ?/* MSC class support */ +#define CONFIG_CMD_STORAGE ? ?/* inclue support for usb-storage cmd */ +#define CONFIG_CMD_FAT ? ? ? ?/* inclue support for FAT/storage */ +#define CONFIG_DOS_PARTITION ?/* inclue support for FAT/storage */ + +#ifdef CONFIG_USB_KEYBOARD ? ? /* HID class support */ +#define CONFIG_SYS_USB_EVENT_POLL + +#define CONFIG_PREBOOT "usb start" +#endif /* CONFIG_USB_KEYBOARD */ +#endif /* CONFIG_MUSB_HCD */ + +#ifdef CONFIG_MUSB_UDC +#define CONFIG_USB_DEVICE ? ? ? ? ? ? ?1 +#define CONFIG_USB_TTY ? ? ? ? ? ? ? ? 1 +#define CONFIG_SYS_CONSOLE_IS_IN_ENV ? 1 +#define CONFIG_USBD_VENDORID ? ? ? ? ? 0x0451 +#define CONFIG_USBD_PRODUCTID ? ? ? ? ?0x5678 +#define CONFIG_USBD_MANUFACTURER ? ? ? "Texas Instruments" +#define CONFIG_USBD_PRODUCT_NAME ? ? ? "DM365VM" +#endif /* CONFIG_MUSB_UDC */ +?/* U-Boot command configuration */
?#include <config_cmd_default.h>--
1.6.2.4
PATCH v2 1/1 musb: Add host support for DM365 EVM
Dear Remy Bohmer,
Quoted 4 lines · In message <[email protected]> you…
Hi Prathap,
Please post patch updates to an existing list in the future. That would increase response times... ;-)
increase or reduce? ;-)
Best regards,
Wolfgang Denk
Signature · 4 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de How does a project get to be a year late? ... One day at a time.