ath9k: configure the beacon only if the STA is associated
PATCH 1/3 ath9k: configure the beacon only if the STA is associated
beacons configuration SHOULD be done only if the STA is associated.
Signed-off-by Senthil Balasubramanian <[email protected]>
--- drivers/net/wireless/ath/ath9k/beacon.c | 8 +++++++- 1 files changed, 7 insertions(+), 1 deletions(-)
drivers/net/wireless/ath/ath9k/beacon.c +7 -1
@@ -577,6 +577,13 @@ static void ath_beacon_config_sta(struct ath_softc *sc,u64 tsf;int num_beacons, offset, dtim_dec_count, cfp_dec_count; +/* No need to configure beacon if we are not associated */ +if (!common->curaid) { +ath_print (common,ATH_DBG_BEACON , +"STA is not yet associated..skipping beacon config\n" ); +return ; + } +memset (&bs,0 ,sizeof (bs)); intval = conf->beacon_interval &ATH9K_BEACON_PERIOD ;
@@ -739,7 +746,6 @@ void ath_beacon_config(struct ath_softc *sc, struct ieee80211_vif *vif)enum nl80211_iftype iftype;/* Setup the beacon configuration parameters */ -if (vif) {struct ieee80211_bss_conf *bss_conf = &vif->bss_conf;
--
1.6.6.1
Quoted 3 lines · Senthil Balasubramanian
beacons configuration SHOULD be done only if the STA is associated.
Signed-off-by Senthil Balasubramanian <[email protected]>
I believe this is Cc: [email protected]
Luis