Skip to contentSkip to conversation

serial: timbuart: Make sure last byte is sent when port is closed

PATCH New Richard Röjfors 1 participant 1 message Mar 16, 2010 TTY layer and serial drivers

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 serial: timbuart: Make sure last byte is sent when port is closed

This patched fixes a problem in early versions of the FPGA IP.

In certain situations the IP reports that the FIFO is empty, but a byte is still clocked out. If a flush is done at that point the currently clocked byte is canceled.
This causes incompatibilities with the upper layers when a port is closed, it waits until the FIFO is empty and then closes the port. During close the FIFO is flushed -> the last byte is not sent properly.

Now the FIFO is only flushed if it is reported to be non-empty. Which makes the currently clocked out byte to finish.

---

drivers/serial/timbuart.c +6 -3
index 7bf1026..aaa1217 100644
@@ -69,10 +69,13 @@ static void timbuart_start_tx(struct uart_port *port)
 
 static void timbuart_flush_buffer(struct uart_port *port)
 {
-	u8 ctl = ioread8(port->membase + TIMBUART_CTRL) | TIMBUART_CTRL_FLSHTX;
+	if (!timbuart_tx_empty(port)) {
+		u8 ctl = ioread8(port->membase + TIMBUART_CTRL) |
+			TIMBUART_CTRL_FLSHTX;
 
-	iowrite8(ctl, port->membase + TIMBUART_CTRL);
-	iowrite32(TXBF, port->membase + TIMBUART_ISR);
+		iowrite8(ctl, port->membase + TIMBUART_CTRL);
+		iowrite32(TXBF, port->membase + TIMBUART_ISR);
+	}
 }
 
 static void timbuart_rx_chars(struct uart_port *port)

--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html