patch s3cmci-initialize-default-platform-data-no_wprotect-and-no_detect-with-1.patch added to 2.6.32-stable tree

This is a note to let you know that we have just queued up the patch titled

Subject: s3cmci: initialize default platform data no_wprotect and no_detect with 1

to the 2.6.32-stable tree. Its filename is

s3cmci-initialize-default-platform-data-no_wprotect-and-no_detect-with-1.patch

A git repo of this tree can be found at
http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary

From: Lars-Peter Clausen <[email protected]>
Date: Fri, 5 Mar 2010 13:43:35 -0800
Subject: s3cmci: initialize default platform data no_wprotect and no_detect with 1

commit c212808a1ba6bfba489006399b8152a047305acf upstream.

If no platform_data was givin to the device it's going to use it's default platform data struct which has all fields initialized to zero. As a result the driver is going to try to request gpio0 both as write protect and card detect pin. Which of course will fail and makes the driver unusable

Previously to the introduction of no_wprotect and no_detect the behavior was to assume that if no platform data was given there is no write protect or card detect pin. This patch restores that behavior.

---
 drivers/mmc/host/s3cmci.c |    2 ++
 1 file changed, 2 insertions(+)

@@ -1361,6 +1361,8 @@ static struct mmc_host_ops s3cmci_ops =
 static struct s3c24xx_mci_pdata s3cmci_def_pdata = {
 	/* This is currently here to avoid a number of if (host->pdata)
 	 * checks. Any zero fields to ensure reaonable defaults are picked. */
+	.no_wprotect = 1,
+	.no_detect = 1,
 };
 
 #ifdef CONFIG_CPU_FREQ

Patches currently in stable-queue which might be from [email protected] are