Fixed checkpatch.pl issues to Line 172 Fixed most problems pointed out by checkpatch.pl in file r8192U_core.c up to line 172
PATCH 1/12 Fixed checkpatch.pl issues to Line 172 Fixed most problems pointed out by checkpatch.pl in file r8192U_core.c up to line 172
From: Mike Gilks <[email protected]>
Signed-off-by Mike Gilks <[email protected]>
--- drivers/staging/rtl8192u/r8192U_core.c | 95 ++++++++++++++++--------------- 1 files changed, 49 insertions(+), 46 deletions(-)
drivers/staging/rtl8192u/r8192U_core.c +49 -46
@@ -25,12 +25,12 @@*/ #ifndef CONFIG_FORCE_HARD_FLOAT -double __floatsidf (int i) {return i; } -unsigned int __fixunsdfsi (double d) {return d; } -double __adddf3 (double a,double b) {return a+b; } -double __addsf3 (float a,float b) {return a+b; } -double __subdf3 (double a,double b) {return a-b; } -double __extendsfdf2 (float a) {return a;} +double __floatsidf (int i) {return i; } +unsigned int __fixunsdfsi (double d) {return d; } +double __adddf3 (double a,double b) {return a+b; } +double __addsf3 (float a,float b) {return a+b; } +double __subdf3 (double a,double b) {return a-b; } +double __extendsfdf2 (float a) {return a; }#endif #undef LOOP_TEST
@@ -58,20 +58,20 @@ double __extendsfdf2(float a) {return a;}#define CONFIG_RTL8192_IO_MAP -#include <asm/uaccess.h> +#include <linux/uaccess.h> #include "r8192U_hw.h" #include "r8192U.h" -#include "r8190_rtl8256.h" /* RTL8225 Radio frontend */ -#include "r8180_93cx6.h" /* Card EEPROM */ +#include "r8190_rtl8256.h" /* RTL8225 Radio frontend */ +#include "r8180_93cx6.h" /* Card EEPROM */ #include "r8192U_wx.h" -#include "r819xU_phy.h" //added by WB 4.30.2008 +#include "r819xU_phy.h" /* added by WB 4.30.2008 */ #include "r819xU_phyreg.h" #include "r819xU_cmdpkt.h" #include "r8192U_dm.h" -//#include "r8192xU_phyreg.h" +/*#include "r8192xU_phyreg.h" */ #include <linux/usb.h> #include <linux/slab.h> -// FIXME: check if 2.6.7 is ok +/* FIXME: check if 2.6.7 is ok */ #ifdef CONFIG_RTL8192_PM #include "r8192_pm.h"
@@ -80,27 +80,30 @@ double __extendsfdf2(float a) {return a;}#ifdef ENABLE_DOT11D #include "dot11d.h" #endif -//set here to open your trace code. //WB -u32 rt_global_debug_component = \ -// COMP_INIT | -// COMP_DBG | -// COMP_EPROM | -// COMP_PHY | -// COMP_RF | -// COMP_FIRMWARE | -// COMP_CH | -// COMP_POWER_TRACKING | -// COMP_RATE | -// COMP_TXAGC | -// COMP_TRACE | -COMP_DOWN | -// COMP_RECV | -// COMP_SWBW | -COMP_SEC | -// COMP_RESET | -// COMP_SEND | -// COMP_EVENTS | -COMP_ERR ;//always open err flags on +/* set here to open your trace code. //WB */ +u32 rt_global_debug_component = +/*COMP_INIT | +*COMP_DBG | +*COMP_EPROM | +*COMP_PHY | +*COMP_RF | +*COMP_FIRMWARE | +*COMP_CH | +*COMP_POWER_TRACKING | +*COMP_RATE | +*COMP_TXAGC | +*COMP_TRACE | +*/ +COMP_DOWN | +/*COMP_RECV | +*COMP_SWBW | +*/ +COMP_SEC | +/*COMP_RESET | +*COMP_SEND | +*COMP_EVENTS | +*/ +COMP_ERR ;/* always open err flags on */ #define TOTAL_CAM_ENTRY 32#define CAM_CONTENT_COUNT 8
@@ -129,21 +132,21 @@ MODULE_VERSION("V 1.1");MODULE_DEVICE_TABLE (usb, rtl8192_usb_id_tbl);MODULE_DESCRIPTION ("Linux driver for Realtek RTL8192 USB WiFi cards" ); -static char * ifname ="wlan%d" ; -static int hwwep =1 ;//default use hw. set 0 to use software security +static char *ifname ="wlan%d" ; +static int hwwep =1 ;/* default use hw. set 0 to use software security */ static int channels =0x3fff ; +module_param (ifname, charp,S_IRUGO |S_IWUSR ); +/*module_param(hwseqnum,int, S_IRUGO|S_IWUSR); */ +module_param (hwwep, int,S_IRUGO |S_IWUSR ); +module_param (channels, int,S_IRUGO |S_IWUSR ); - -module_param (ifname, charp,S_IRUGO |S_IWUSR ); -//module_param(hwseqnum,int, S_IRUGO|S_IWUSR); -module_param (hwwep,int,S_IRUGO |S_IWUSR ); -module_param (channels,int,S_IRUGO |S_IWUSR ); - -MODULE_PARM_DESC (ifname," Net interface name, wlan%d=default" ); -//MODULE_PARM_DESC(hwseqnum," Try to use hardware 802.11 header sequence numbers. Zero=default"); -MODULE_PARM_DESC (hwwep," Try to use hardware security support. " ); -MODULE_PARM_DESC (channels," Channel bitmask for specific locales. NYI" ); +MODULE_PARM_DESC (ifname," Net interface name, wlan%d=default" ); +/*MODULE_PARM_DESC(hwseqnum, " Try to use hardware 802.11 header sequence +* numbers. Zero=default"); +*/ +MODULE_PARM_DESC (hwwep," Try to use hardware security support. " ); +MODULE_PARM_DESC (channels," Channel bitmask for specific locales. NYI" );static int __devinit rtl8192_usb_probe (struct usb_interface *intf,const struct usb_device_id *id);
@@ -160,7 +163,7 @@ static struct usb_driver rtl8192_usb_driver = { .resume = rtl8192_resume, /* PM resume fn */ #else .suspend = NULL, /* PM suspend fn */ - .resume = NULL, /* PM resume fn */ + .resume = NULL, /* PM resume fn */#endif };
Signature · 1 line
1.6.3.3