Question regarding LP NAND chip with built-in ECC

I'm working to add support for a new 2KiB page NAND chip on OMAP3 that has built in ECC - the chip calculates the ECC on writes and programs the ECC into the OOB area, leaving 16 bytes (out of 64) usable for OOB information. On reads the chip reads the page into the read buffer caculating/correcting the ECC in the process and updating the status with the result.

My problem is trying to figure out the best way to add support for it in the current MTD NAND structure while modifying a minimal amount of code.

The chip requires on reads to send the following (starting with the normal read sequence):

0x00 C1 C2 R1 R2 R3 0x30

At this point wait for tR_ECC, then read the status back to determine if a hard/soft ECC occured:

0x70 <status>

Then issue the READSTART command:

0x00

and then read out the data.

Writes appear to be handled normally.

I was wondering if anyone has run across a chip such as this

I was thinking of adding NAND_ECC_CHIP as a new ECC mode and creating nand_read_page_chipecc() to handle the reads and use the ecc entrypoints for NAND_ECC_NONE to handle the other functions.

Would this work?

Peter Barada <[email protected]>