Skip to contentSkip to conversation

Skip looking for ioapic overrides when ioapics are not present

DISCUSSION Guido Trentalancia 1 participant 1 message Aug 6, 2010

lore
Share & tools
lore
#0 lore raw

I have applied the patch below to the 2.6.35 kernel and it finally stopped reporting "Unable to locate IOAPIC for GSI..." on bootup.

Quoted 46 lines

Eric W. Biederman writes on 2010-06-06 03:56:05

Quoted 5 lines · Avinash Kurup

Hi Eric,
I get the following errors while booting into 2.6.35-rc1. I did not
get these in 2.6.34 . The computer however boots and works fine, So its not serious but the following errors are displayed in dmesg.

Quoted 7 lines
[    0.089969] ERROR: Unable to locate IOAPIC for GSI 13
[    0.090556] ERROR: Unable to locate IOAPIC for GSI 8
[    0.091104] ERROR: Unable to locate IOAPIC for GSI 12
[    0.091375] ERROR: Unable to locate IOAPIC for GSI 1
[    0.093195] ERROR: Unable to locate IOAPIC for GSI 4
[    0.094342] ERROR: Unable to locate IOAPIC for GSI 10
[    0.096335] ERROR: Unable to locate IOAPIC for GSI 6

The new warning originates from acpi_get_override_irq, which I changed to use helper functions that warn when they fail.

When IOAPICs and ACPI are enabled in a kernel and run on ACPI hardware that doesn't use the ioapics the pnp acpi code calls this function, looking for ACPI irq overrides. ACPI irq overrides exist only in the ioapic case so this function will never succeed. So make the function fail fast so we don't call into help functions that legitimately complain when they fail.

---

arch/x86/kernel/apic/io_apic.c +3 -0
index 33f3563..226a6d1 100644
@@ -4066,6 +4066,9 @@  int acpi_get_override_irq(u32 gsi, int *trigger, int *polarity)
 {
 	int ioapic, pin, idx;
 
+	if (acpi_irq_model != ACPI_IRQ_MODEL_IOAPIC)
+		return -1;
+
 	if (skip_ioapic_setup)
 		return -1;