arm: remove CONFIG_RELOC_FIXUP_WORKS in board config files
PATCH 1/1 arm: remove CONFIG_RELOC_FIXUP_WORKS in board config files
As this define is valid for all arm boards, this define is no longer needed in board config files, as it is defined in arch/arm/include/asm/config.h
Signed-off-by Heiko Schocher <[email protected]>
--- include/configs/imx27lite-common.h | 1 - include/configs/omap3_beagle.h | 1 - include/configs/tx25.h | 2 -- 3 files changed, 0 insertions(+), 4 deletions(-)
include/configs/imx27lite-common.h +0 -1
@@ -236,7 +236,6 @@"mtdparts=" MTDPARTS_DEFAULT "\0" \ /* additions for new relocation code, must added to all boards */ -#define CONFIG_RELOC_FIXUP_WORKS #define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1 #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_SDRAM_BASE + 0x1000 - /* Fix this */ \CONFIG_SYS_GBL_DATA_SIZE )
include/configs/omap3_beagle.h +0 -1
@@ -341,7 +341,6 @@ extern unsigned int boot_flash_type;#endif /* additions for new relocation code, must added to all boards */ -#define CONFIG_RELOC_FIXUP_WORKS #define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1#define CONFIG_SYS_INIT_SP_ADDR (LOW_LEVEL_SRAM_STACK - CONFIG_SYS_GBL_DATA_SIZE)
include/configs/tx25.h +0 -2
@@ -177,8 +177,6 @@"upd=run load update\0" \ /* additions for new relocation code, must added to all boards */ -#undef CONFIG_SYS_ARM_WITHOUT_RELOC/* This board is tested with relocation support */ -#define CONFIG_RELOC_FIXUP_WORKS #define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1 #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_SDRAM_BASE + 0x1000 - /* Fix this */ \CONFIG_SYS_GBL_DATA_SIZE )
Signature · 1 line
1.7.2.3
PATCH 1/1 arm: remove CONFIG_RELOC_FIXUP_WORKS in board config files
Dear Heiko Schocher,
Quoted 10 lines · In message <[email protected]> you wrote:
As this define is valid for all arm boards, this define is no longer needed in board config files, as it is defined in
arch/arm/include/asm/config.hSigned-off-by Heiko Schocher <[email protected]>--- include/configs/imx27lite-common.h | 1 - include/configs/omap3_beagle.h | 1 - include/configs/tx25.h | 2 -- 3 files changed, 0 insertions(+), 4 deletions(-)
This has already been fixed in elf_reloc.
Best regards,
Wolfgang Denk
Signature · 5 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de A meeting is an event at which the minutes are kept and the hours are lost.