Documentation: gpio: Clarify usage of poll(2)
PATCH 1/1 Documentation: gpio: Clarify usage of poll(2)
Add a bit more information how to use poll(2) on GPIO value files correctly. For me it was not clear that I need to poll(2) for POLLPRI|POLLERR or select(2) for exceptfds.
Signed-off-by Bernhard Walle <[email protected]>
--- Documentation/gpio.txt | 10 ++++++++++ 1 files changed, 10 insertions(+), 0 deletions(-)
Documentation/gpio.txt +10 -0
@@ -617,6 +617,16 @@ and have the following read/write attributes: is configured as an output, this value may be written; any nonzero value is treated as high. + If the pin can be configured as interrupt-generating interrupt + and if it has been configured to generate interrupts (see the + description of "edge"), you can poll(2) on that file and + poll(2) will return whenever the interrupt was triggered. If + you use poll(2), set the events POLLPRI and POLLERR. If you + use select(2), set the file descriptor in exceptfds. After + poll(2) returns, either lseek(2) to the beginning of the sysfs + file and read the new value or close the file and re-open it + to read the value. + "edge" ... reads as either "none", "rising", "falling", or "both". Write these strings to select the signal edge(s) that will make poll(2) on the "value" file return.
Signature · 1 line
1.7.1