Skip to contentSkip to conversation

Support for matroxfb on HP Vectra

PATCH New Petr Vandrovec 1 participant 1 message Mar 14, 2003 2 messages not in the archive Framebuffer layer

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

#2 lore raw

PATCH 1/1 Support for matroxfb on HP Vectra

Hi Marcelo,
please apply this patch...

Matrox chips soldered to the HP Vectra's mainboard do not have EEPROM connected to them, instead of that system BIOS contains VGA BIOS image which is extracted only to the legacy VGA BIOS region at 0xC0000, and nowhere else. And in addition to this they decided to use 14.318MHz XTAL instead of recommended 27.000MHz. These two events together made matroxfb a bit unhappy on such motherboard, as all frequencies were only 53% of expected value :-(

With this patch matroxfb tries to use legacy BIOS if there is no EEPROM and it is ia32 architecture (and it was confirmed to fix a problem).

Patch applies to both 2.4 and 2.5, but in 2.5 it is a bit useless...

Thanks,
Petr Vandrovec [email protected]

drivers/video/matrox/matroxfb_misc.c +21 -0
@@ -994,6 +994,27 @@
 	parse_bios(vaddr_va(ACCESS_FBINFO(video).vbase), &ACCESS_FBINFO(bios));
 	pci_write_config_dword(pdev, PCI_ROM_ADDRESS, biosbase);
 	pci_write_config_dword(pdev, PCI_OPTION_REG, opt);
+#ifdef CONFIG_X86
+	if (!ACCESS_FBINFO(bios).bios_valid) {
+		unsigned char* b;
+		
+		b = ioremap(0x000C0000, 65536);
+		if (!b) {
+			printk(KERN_INFO "matroxfb: Unable to map legacy BIOS\n");
+		} else {
+			unsigned int ven = readb(b+0x64+0) | (readb(b+0x64+1) << 8);
+			unsigned int dev = readb(b+0x64+2) | (readb(b+0x64+3) << 8);
+			
+			if (ven != pdev->vendor || dev != pdev->device) {
+				printk(KERN_INFO "matroxfb: Legacy BIOS is for %04X:%04X, while this device is %04X:%04X\n",
+					ven, dev, pdev->vendor, pdev->device);
+			} else {
+				parse_bios(b, &ACCESS_FBINFO(bios));
+			}
+			iounmap(b);
+		}
+	}
+#endif
 	matroxfb_set_limits(PMINFO &ACCESS_FBINFO(bios));
 }