Mode setting not working with SandyBridge.
Hello,
I have a HTPC with a Core i3-2120T with an Intel DH67GD motherboard. I'm running Debian Wheezy/Sid. Versions for key software on the system are as follows.
- kernel: linux 3.1.0, 3.1.5, 3.2.0-rc6
- 3D driver: mesa 7.11.1
- 2D driver: xserver-xorg-video-intel 2.17.0
- libdrm: libdrm-intel1 2.4.27
- xserver: X.Org 1.11.2
When connected (via HDMI) to my Sony Wega TV, the display is normal during POST, the GRUB menu, and the first few seconds of booting the OS. Shortly thereafter, the screen goes dark with horizontal lines that flicker lines. If I use the boot parameter 'acpi=off', the video output is fine albeit at the `normal' size of 80x25.
Video output from the HTPC is fine when connected (via HDMI) to my LG 246WHX monitor.
I have a Dell laptop with a GMA X3100 graphics core (GM965 chipset) and I am able to successfully use with the TV (connected via HDMI). Below are the modes "probed for output" by the laptop; I've successfully used the modes "1280x720" and "720x480" in the past:
Modeline "1280x720"x60.0 74.25 1280 1390 1430 1650 720 725 730 750
+hsync +vsync
Modeline "720x480"x59.9 27.00 720 736 798 858 480 489 495 525 -hsync
-vsync
Modeline "640x480"x60.0 25.20 640 656 752 800 480 490 492 525 -hsync
-vsync
My guess is that the graphics driver on the HTPC is attempting to use timings that are incompatible with the TV. Here's what I get when I query the frame buffer --- note the `timings' line:
# fbset -i
mode "1280x720"
geometry 1280 720 1280 720 32
timings 0 0 0 0 0 0 0
accel true
rgba 8/16,8/8,8/0,0/0endmode
Frame buffer device information:
Name : inteldrmfb
Address : 0xe0063000
Size : 3686400
Type : PACKED PIXELS
Visual : TRUECOLOR
XPanStep : 1
YPanStep : 1
YWrapStep : 0
LineLength : 5120Accelerator : No
I tried to specify the device timings myself using fbset but it doesn't seem like one is able to change the timings after they have already been set?
# fbset -fb /dev/fb0 -pixclock 13468 -left 220 -right 110 -upper 20 -lower 5 -hslen 40 -vslen 5 -hsync high -vsync high
ioctl FBIOPUT_VSCREENINFO: Invalid argument
I'm looking to help troubleshoot and hopefully fix this problem as best as I can. Can anyone confirm the cause of the problem? Assuming that the problem is with incompatible mode setting, in the interim, is it possible, say via a boot parameter, to specify the mode that the video driver would use? Thanks.
Until next time, Colin.