ALSA: ASoC: add codec driver for TI TAS5086
Subsystems (3)
PATCH v2 1/1 ALSA: ASoC: add codec driver for TI TAS5086
This patch adds a driver for TI's TA5086 6-channel PWM processor.
This chip has a very unusual register layout, specifically because the registers are of unequal size, and multi-byte registers require bulk writes to take effect. Regmap does not support these kind of mappings.
Currently, the driver does not touch any of the registers >= 0x20, so it doesn't matter, because the register map is mapped to an 8-bit array. In case more features will be added in the future that require access to higher registers, the entire regmap H/W I/O routines have to be open-coded.
---
v2:
* define clock indices in a header
* switched to switch-case in some places
* dropped empty suspend function
* moved device id checks and gpio allocations to i2c level
* switched to mute_stream()
.../devicetree/bindings/sound/ti,tas5086.txt | 32 ++ include/sound/tas5086.h | 7 + sound/soc/codecs/Kconfig | 4 + sound/soc/codecs/Makefile | 2 + sound/soc/codecs/tas5086.c | 601 +++++++++++++++++++++ 5 files changed, 646 insertions(+) create mode 100644 Documentation/devicetree/bindings/sound/ti,tas5086.txt create mode 100644 include/sound/tas5086.h create mode 100644 sound/soc/codecs/tas5086.c
Documentation/devicetree/bindings/sound/ti,tas5086.txt new file +32 -0
@@ -0,0 +1,32 @@ +Texas Instruments TAS5086 6-channel PWM Processor + +Required properties: + + - compatible: Should contain "ti,tas5086". + - reg: The i2c address. Should contain <0x1b>. + +Optional properties: + + - reset-gpio: A GPIO spec to define which pin is connected to the + chip's !RESET pin. If specified, the driver will + assert a hardware reset at probe time. + + - ti,charge-period: This property should contain the time in microseconds + that closely matches the external single-ended + split-capacitor charge period. The hardware chip + waits for this period of time before starting the + PWM signals. This helps reduce pops and clicks. + + When not specified, the hardware default of 1300ms + is retained. + +Examples: + + i2c_bus { + tas5086@1b { + compatible = "ti,tas5086"; + reg = <0x1b>; + reset-gpio = <&gpio 23 0>; + ti,charge-period = <156000>; + }; + };
include/sound/tas5086.h new file +7 -0
@@ -0,0 +1,7 @@ +#ifndef _SND_SOC_CODEC_TAS5086_H_ +#define _SND_SOC_CODEC_TAS5086_H_ + +#define TAS5086_CLK_IDX_MCLK 0 +#define TAS5086_CLK_IDX_SCLK 1 + +#endif /* _SND_SOC_CODEC_TAS5086_H_ */
sound/soc/codecs/Kconfig +4 -0
@@ -64,6 +64,7 @@ config SND_SOC_ALL_CODECS select SND_SOC_STA32X if I2C select SND_SOC_STA529 if I2C select SND_SOC_STAC9766 if SND_SOC_AC97_BUS + select SND_SOC_TAS5086 if I2C select SND_SOC_TLV320AIC23 if I2C select SND_SOC_TLV320AIC26 if SPI_MASTER select SND_SOC_TLV320AIC32X4 if I2C
@@ -324,6 +325,9 @@ config SND_SOC_STA529 config SND_SOC_STAC9766 tristate +config SND_SOC_TAS5086 + tristate + config SND_SOC_TLV320AIC23 tristate
sound/soc/codecs/Makefile +2 -0
@@ -56,6 +56,7 @@ snd-soc-ssm2602-objs := ssm2602.o snd-soc-sta32x-objs := sta32x.o snd-soc-sta529-objs := sta529.o snd-soc-stac9766-objs := stac9766.o +snd-soc-tas5086-objs := tas5086.o snd-soc-tlv320aic23-objs := tlv320aic23.o snd-soc-tlv320aic26-objs := tlv320aic26.o snd-soc-tlv320aic3x-objs := tlv320aic3x.o
@@ -179,6 +180,7 @@ obj-$(CONFIG_SND_SOC_SSM2602) += snd-soc-ssm2602.o obj-$(CONFIG_SND_SOC_STA32X) += snd-soc-sta32x.o obj-$(CONFIG_SND_SOC_STA529) += snd-soc-sta529.o obj-$(CONFIG_SND_SOC_STAC9766) += snd-soc-stac9766.o +obj-$(CONFIG_SND_SOC_TAS5086) += snd-soc-tas5086.o obj-$(CONFIG_SND_SOC_TLV320AIC23) += snd-soc-tlv320aic23.o obj-$(CONFIG_SND_SOC_TLV320AIC26) += snd-soc-tlv320aic26.o obj-$(CONFIG_SND_SOC_TLV320AIC3X) += snd-soc-tlv320aic3x.o
sound/soc/codecs/tas5086.c new file +601 -0
601 lines not on this page · raw message
Signature · 1 line
1.8.1.4
Mark Brown
AppliedQuoted 5 lines · Daniel Mack
This patch adds a driver for TI's TA5086 6-channel PWM processor.
This chip has a very unusual register layout, specifically because the registers are of unequal size, and multi-byte registers require bulk writes to take effect. Regmap does not support these kind of mappings.
Applied, thanks.