Skip to contentSkip to conversation

More detail: Re: visor.ko freezes on dlpsh list

DISCUSSION [email protected] 3 participants 3 messages Dec 16, 2004

lore
Share & tools
lore
#0 lore raw

It is the visor.[ch] of vmlinuz-2.6.9-1.681_FC3 that does not work. I recompiled a linux-2.6.9 kernel and the pilot-xfer, dlpsh, and kpilot work now. It is the visor.[ch] in vmlinuz-2.6.9-1.681_FC3 that is the culprit.

-----Forwarded Message-----
From: [email protected]
Sent: Dec 15, 2004 5:47 AM
To: Greg KH <[email protected]>
Subject: Re: visor.ko freezes on dlpsh list

You asked: What kernel version are you using?
vmlinuz-2.6.9-1.681_FC3,
but the original Fedora Core 3 did not work either.
It was suggested to remove the visor diffs from the ac10 patch and that would work. I may try building linux-2.6.9 and see how that works.

Bill Chimiak

-----Original Message-----
From: Greg KH <[email protected]>
Sent: Dec 13, 2004 11:14 PM
To: Bill Chimiak <[email protected]>
Cc: [email protected]
Subject: Re: visor.ko freezes on dlpsh list

Quoted 4 lines · Bill Chimiak

Summary: Handspring visor does not fully sync with kpilot or jpilot or with pilot-xfer.
With dlpsh, the user, and df work but it freezes with a ls command after completing about 75% to 80% of the actually listing.

What kernel version are you using?
thanks,
greg k-h

#1 lore raw
Quoted 3 lines · On Iau, 2004-12-16 at 16:43, [email protected] wrote:

It is the visor.[ch] of vmlinuz-2.6.9-1.681_FC3 that does not work. I recompiled a linux-2.6.9 kernel and the pilot-xfer, dlpsh, and kpilot work now. It is the visor.[ch] in vmlinuz-2.6.9-1.681_FC3 that is the culprit.

That would make sense. Vanilla 2.6.9 has the visor denial of service hole (and a mass of other holes but none of the others touch visor). The earlier fix had a bug in it and is in 681_FC3, the full fix is in the later kernels and in current 2.6.9-ac and should work fine.

#2 lore raw
In reply to [email protected]
Quoted 3 lines · On Thu, Dec 16, 2004 at 08:43:33AM -0800, [email protected] wrote:

It is the visor.[ch] of vmlinuz-2.6.9-1.681_FC3 that does not work. I recompiled a linux-2.6.9 kernel and the pilot-xfer, dlpsh, and kpilot work now. It is the visor.[ch] in vmlinuz-2.6.9-1.681_FC3 that is the culprit.

Yes, that makes sense (see what Alan said.) If you want to have fixes for this driver, either use the 2.6.10-rc3 kernel, or the 2.6.9-ac tree.

thanks,

greg k-h